Installation Guide

ManualsBrandsJELD-WEN ManualsKitchen72 in. x 80 in. White Right Hand Vinyl Patio Door with Low-E Argon Glass, Grids and Small Pet Door

INSTALLATION INSTRUCTIONS

for Vinyl Patio Doors with Integral Nailing Fin (JII006)

Premium Doors Only

9b.Fastenthrough

nailing n holes

with#8x1truss

head screws. At

the head, screws

should be driven

4"fromthe

cornersand4"

apart. For step-

down landings,

secure the sill in

the same manner

as the head. Fasten

the side jambs at

8" intervals.

SECURE PATIO DOOR

Note! Fastener heads

must be ush. Do

not dent nailing n.

Always use pre-

punched holes or pre-

drill with a 3/16" bit.

Builders Doors Only

9a.Fastenpatiodoor

through nailing n

holes4"fromthe

corners and 12"

apart all the way

around the patio

door.

SHIM THE JAMBS

Note! Secure all shims with sealant.

5.Fromtheinterior,

shim the operating

panel side jamb 6"

from the corners

and at the strike

plate. Align shims

so that strike plate

screws (installed

later) will each

penetrate a shim.

6. Shim the stationary

panel side jamb 6"

from the corners

and at center.

7.Shimthehead

jamb 6" from the corners of each panel.

8. Inspect the patio door for square, level, and plumb. Test for proper

operation (remove and reinstall if necessary).

Warning! To avoid injury, use at least two people to install.

1. For continuous

slab landings only,

remove nailing n

at sill.

2.Applya3/8"

continuous bead of

sealant across the

sill pan back dam.

3.Tiltpatiodoorinto

the rough opening.

Make sure the

back of the door

makes solid contact

with the sealant.

Adequately support

the door until fully

installed.

4.Fastenpatiodoor

withagalvanized

roong nail between

3"and4"fromone

lower corner.

INSTALL PATIO DOOR

FLASH PATIO DOOR

Sealant

3"-4"

Strike

plate

Interior

12"

Builders Patio Door

Premium Patio Door

PREPARE FLASHING

1.CutpiecesofJELD-WENself-adhesiveashingtolength

as follows:

•Oneheaderpiece14"longerthantheheader

•Twosidepieces:forcontinuousslablandings,5"longerthanthe

sides,orforstep-downlandings,5"+theheightofthestep

•Forstep-downlandingsonly,onesillpiece10"longerthanthesill

and 1" narrower than the height of the step

SPRAY ADHESIVE/PRIMER

2. Apply spray adhesive

permanufacturer’s

instructions

(protect door from

overspray) to nailing

n, sheathing,

and building wrap

around the patio

door as shown.