Instructions / Assembly

ManualsBrandsJELD-WEN ManualsBay & Bow Windows73.5 in. x 61 in. V-4500 Series Bay Vinyl Window - White

INSTALLATION INSTRUCTIONS

for Vinyl Projecting Windows with Integral Nailing Fin (JII023)

4. Press the

adhesive

section of the

ashing onto

outside section

of sill.

5. Pull release

tape on

remaining

section of the

ashing.

6. Fold the

ashing down

onto the house

wrap.

7. Staple ashing

to the wall and

seal the corner

edges.

Note! The sill lip is the garden window’s only source of support inside

the rough opening. It is very important that the sill be level and at.

1. Measure the

length of the

sill and cut

a piece of

ashing the

exact length of

the sill.

2. Measure and

draw a line

1/2" from the

exterior edge

of the sill; this

is where the

ashing will sit.

3. Remove foam

backing and

release tape

under foam

backing.

1/2"

Width of

rough opening

PREPARE SILL FOR GARDEN WINDOW

Release

tape

Seal

corners

3. Inspect window for square, level, and plumb. Test for proper

operation (remove and reinstall if necessary).

Note! Fastener

heads must be

ush. Do not

dent nailing n.

Always use pre-

punched holes or

pre-drill with a

3/16" bit.

4. Fasten window

through nailing

n holes 3"-

7" from the

corners and 8"

apart all the

way around

the window.

3"-7"

INSTALL GARDEN WINDOW

Warning! To avoid injury, use at least two people to install. Temporarily

support the window until fully installed.

1. Place window

sill onto the

drain mat and

tilt into the

rough opening.

The window

sill must rest

on and be fully

supported

by the rough

opening

framing.

2. Fasten

window with

a galvanized

roong nail

through the nailing n between 3"-7" from one lower corner.

3"-7"