Full Product Manual

4
PRODUCT GUIDE
Vinyl Patio Doors (JPG008)
HARDWARE ADJUSTMENT - CONTINUED
ROLLER ADJUSTMENT
Note! Adjusting door too high may allow water and air leakage. Adjust
rollers just high enough to clear sill track and keep the weatherstrip
hidden when the door is closed.
1. Builders doors have an adjustment screw on each lower end of the
operating panel(s). Premium doors (and some older Builders doors)
have access holes on the face of each lower end of the operating
panel(s). Remove small vinyl plugs from each hole (if present).
2. Open operating panel enough to compare with frame jamb.
Note! Builders roller
adjustment screws
are in close proximity
to the attachment
screw. Adjust only
the lower screw (as
shown); loosening the
attachment screw will
detach the roller from
the operating panel.
3. Lift the panel to take
the weight off of the
roller and turn the
adjustment screw
with a #2 Phillips
head screwdriver
(do not use a power
driver). Clockwise rotations raise the panel, and counterclockwise
rotations lower the panel.
4. Adjust as needed until interlocks, grid patterns, and jambs line up.
5. Test the operating panel for proper operation.
6. Re-apply the small vinyl caps over the roller adjustment screw holes
ifapplicable.
Raise
panel
Lower panel
Attachment
screw
End adjustment
Face
adjustment
Adjustment
screw
LOCK ADJUSTMENT
Some locks are not
adjustable. Adjustable
locks will have a lock
hook adjustment screw
and non-adjustable
locks will not. Keepers
vary in design, but
operate similarly.
IF THE LOCK DOES NOT PROPERLY ENGAGE THE STRIKE PLATE
Loosen the strike plate
screws and move up or
down until the latch
engages properly.
IF THE DOOR DOES
NOT LOCK OR IS LOOSE
WHEN LOCKED
Turn the latch
adjustment screw(s)
in 1/2 turn increments
clockwise to extend the
hook, loosening the
locking mechanism, or
counterclockwise to
retract the hook and
tighten the locking
mechanism. Premium
doors have a double
latch and two adjustment screws.
Blinds Between the Glass
OPERATION
• When blinds are fully tilted closed, you will not be able to see
through the blinds at eye level, only when looking down. Shades
provide complete privacy.
• For easiest operation, operate at a medium speed and keep the slats
in a fully open position while operating.
• It is normal to have a small gap at the bottom at full drop. The blinds
may also not be perfectly level when fully open.
ADJUSTMENTS
1. If the operator comes off of the track, hold the operator at a sharp
angle to the glass and reinsert the two legs under the track opening.
2. Re-couple the operator magnets.
RE-COUPLE OPERATOR MAGNETS
1. Slide the operator past the half-way engagement point until the
rstclick.
2. Continue to the full engagement point until the second click.
TROUBLESHOOTING
• Most problem conditions can be corrected by exercising the blinds in
the fully open position. Fully cycle the blind from top to bottom and
repeat if necessary.
• If de-coupling continues to the point the blinds cannot be fully raised
or lowered, an internal failure has occurred. Please contact us for
replacement options.
Strike
plate
Lock hook
adjustment
screw
Lock hook
adjustment screw
Lock hook
adjustment screw
05/20