Full Product Manual

5
PRODUCT GUIDE
Vinyl Patio Doors (JPG008)
HARDWARE ADJUSTMENT - CONTINUED
Multi-Panel Sliding Panel Shoot Bolt Adjustment
This door consists of
two operating panels:
an active panel with
a handle and locking
mechanism and an
inactive panel with just
a handle. The inactive
panel contains a shoot
bolt that is designed
to secure the inactive
panel in place and
allow the active panel
to lock into it.
Shoot Bolt Adjustment:
1. Adjust the rollers as
described above.
2. Completely close
the inactive panel
and open the active
panel.
3. If the shoot bolt
will not properly
engage into the
keeper, loosen the
four screws and slide
the keeper back and
forth until the lock
engages properly.
Re-tighten all screws.
4. Engage the shoot bolt into the keeper and verify there is at least
a gap of 1/16" between the end of the shoot bolt and the frame
header. If necessary, perform shoot bolt height adjustment.
5. Check door for proper operation and readjust as necessary.
Shoot Bolt Height Adjustment:
Adjust the height of the shoot bolt if it touches the head or if it isn't
high enough to properly engage in the keeper.
Note! Patio door panels are very heavy. Removal and installation
requires two or more people.
1. Remove the inactive panel from the door. The rollers may need to be
adjusted up into the panel to clear the sill track. Slide the panel to an
open position and lift up and over the sill track.
2. Remove the screw and the sleeve.
3. Turn the shoot bolt clockwise to shorten it’s height and
counterclockwise to increase it’s height. Only increase it enough to
engage into the keeper and leave 1/16" gap at the frame header.
If the shoot bolt hits the frame header, it will not fully lock when
engaged.
Note! The shoot bolt only has 7/16" of adjustment.
4. When the desired
height is achieved,
replace the sleeve
and screw.
5. Reinstall the inactive
panel back into
the frame and
re-adjust the rollers
as necessary.
6. Check door for
proper operation
and readjust as
necessary.
1/16"
Shoot
bolt
Shoot bolt
keeper
Inactive
panel
Fixed
panel
Inactive
panel
Active
panel
Fixed
panel
Attachment
screws
Frame
header
Shoot
bolt
Sleeve
05/20