Instructions / Assembly

Installation Instructions
for Vinyl Patio Doors with Integral Nailing Fin (JII006)
11
REMOVE PROTECTIVE FILM
8
Patio door panels are very heavy. Removal and
installation require two or more people.
Shoot Bolt Height Adjustment:
• Remove the inactive panel from the door frame. The rollers may need to
be adjusted up into the panel to clear the sill track. Slide the panel to an
open position and lift it up and over the sill track.
• Place the door on sawhorses. At the head of the panel, remove the
screw and the sleeve.
• Turn the shoot bolt clockwise to shorten the height and
counterclockwise to increase the height. Only increase it enough to
engage into the keeper and leave 1/16" gap at the frame header. If the
shoot bolt hits the frame header, it will not fully lock whenengaged.
NOTE: The shoot bolt only has 7/16" of adjustment.
• When the desired height is
achieved, replace the sleeve
andscrew.
Shoot
bolt
Sleeve
9. Reinstall the inactive panel back into the frame and re-adjust the
rollers asnecessary.
10. Check the door for proper operation.
11. Adjust the keeper as necessary by loosening the four screws and
sliding up or down until the lock
engages properly. Tighten all screws.
Lock Adjustment
NOTE: If the strike plate was not previously installed, line up the
screw holes with the dimples in the operating panel side jamb and
drive screws through the two slotted screw holes.
If the lock does not properly engage the strike plate:
• Loosen the strike plate screws and move the plate up or down until the
latch engages properly.
If the door does not lock or is loose when locked:
• Turn the latch adjustment screw(s) in 1/2 turn increments: clockwise to
loosen or counterclockwise to tighten. Premium doors have a double
latch and two adjustment screws.
Builders Patio Door
Premium Patio Door
Lock hook
adjustment
screw
Lock hook
adjustment
screw
Lock hook
adjustment
screw
Strike
plate