Instructions / Assembly

Installation Instructions
for Vinyl Windows with Integral Nailing Fin (JII001)
Please visit jeld-wen.com for warranty
and care and maintenance information.
Thank you for choosing
JII006 3/23
©2023 JELD-WEN, Inc. This publication and its contents are owned by or licensed to JELD-WEN, Inc. or its afliates or third parties, and are protected by copyright, trademark, and other laws. Unauthorized use
or duplication is prohibited. JELD-WEN reserves the right to change product specications without notice. Please visit our website at jeld-wen.com for current information.
All rights reserved.
REMOVE PROTECTIVE FILM
8
Premium Patio DoorBuilders Patio Door
Replacement
screw
Pre-installed
screw
Pre-installed
screw
Pre-installed
screw
Pre-installed
screw
Builders Patio Door
Interior
Replacement
screw
Bumper
Anchor Fastening
1. For 2-panel door systems, drive two #10 x 2 1/2" screws through the
open screw holes in the strike plate (included in the hardware pack).
NOTE: Screws should penetrate through the door frame, shims and
embed into a rough framing member.
2. Shut the door and test for locking capability. If an adjustment is
needed, reference the “Lock Adjustment” section and/or adjust
rollers.
3. Once the lock is adjusted, remove the pre-drilled screws from the
strike plate and replace them with the remaining #10 x 2 1/2" screws
from the hardware pack. This will secure the patio door to
the structure.
Install Bumper
For Builders vinyl series doors, install the bumper in the stationary panel
side jamb at vertical center using the 1" self-tapping screw provided.