Instructions / Assembly

IMPORTANT INFORMATION
|
TABLE OF CONTENTS
|
GLOSSARY
SAFETY AND HANDLING
Installation Instructions
for Vinyl Patio Doors with Integral Nailing Fin (JII006)
3
JELD-WEN does not endorse the installation of our products
into a barrier-type install system unless a sill pan is present,
incorporated with through-wall ashing and can drain to the
exterior (along with other “required” components). Failure to
do so may result in the denial of any warranty claims.
JELD-WEN advises against product installation in
high interior water exposure environments such as
showers, steam rooms and enclosed pool areas. These
areas are beyond the tested/certied design intent of
the product and any related warranty claims could be
denied on that basis.
Glossary
Buck
A wood framework attached to the masonry inside a patio door rough opening.
Mulled Unit
An assembly of two or more individual products that will be installed into a
single rough opening. Mullion elements may be horizontal, vertical or both.
Pilot Hole
A drilled hole that is no larger than the body of the screw (minus the threads).
Score
Make a cut mark in the same location multiple times.
Self-Adhered Flashing
An adhesive-backed tape material used to waterproof the rough opening
and/or used to seal a patio door to the building’s weather barrier.
Shiplap
The layering method in which each layer overlaps the layer below it so that
water runs down the outside.
Weep Hole (weep channel)
The visible exit or entry part of a water drainage system used to drain
water out of a patio door.
Safety
• Read and fully understand ALL manufacturers’ instructions before
beginning. Failure to follow proper installation instructions may result in
the denial of warranty claims for operational or performanceproblems.
• DO NOT work alone. Two or more people are required. Use safe
liftingtechniques.
• Use caution when handling glass. Broken or cracked glass can cause
serious injury.
• Wear protective gear (e.g. safety glasses, gloves, ear protection, etc.).
• Operate hand/power tools safely and follow the manufacturer’s
operating instructions.
• Use caution when working at elevated heights.
• If disturbing existing paint, take proper precautions if lead paint is
suspected (commonly used before 1979). Your regional EPA
(www.epa.gov/lead) or Consumer Product Safety Commission ofces
provide information regarding regulations and lead protection.
Patio Door Handling
• Make sure the operating panel is secured prior to installation.
• Heed material manufacturers’ handling and application instructions.
• Handle in a vertical position; DO NOT carry at or drag on the oor.
• DO NOT put stress on joints, corners or frames.
• Store window in a vertical, leaning position to allow air circulation;
DO NOT stack horizontally.
• Ensure the storage area is dry, well-ventilated and protected from
exposure to direct sunlight.
• Only install into vertical walls when conditions/sheathing aredry.
IF INJURY OCCURS, IMMEDIATELY SEEK MEDICAL ATTENTION!
Table of Contents
Safety and Handling .......................................3
Materials and Tools .......................................4
Inspect Product ...........................................4
Inspect Rough Opening (R.O.) ...............................5
Install Sill Pan Flashing System ...............................6
Temporarily Fasten and Shim Product .........................7
Fasten Product (Size and Spacing) ............................8
Install Drip Cap ...........................................9
Create “Interior” Air Seal ...................................9
Remove Protective Film ....................................9
Drilling, sawing, sanding or machining wood products
can expose you to wood dust, a substance known to
the State of California to cause cancer. Avoid inhaling
wood dust or use a dust mask or other safeguards
for personal protection. For more information, go to
www.P65Warnings.ca.gov/wood.
PLEASE NOTE: Installations where the sill is higher than 35 feet above
ground level, or any product installation into a wall condition not
specically addressed in these instructions, must be designed by an
architect or structural engineer. Failure to install patio doors into a square,
level, and plumb openings could result in denial of warranty claims for
operational or performance problems.
NOTE TO INSTALLER: Provide a copy of these instructions to the
building owner. By installing this product, you acknowledge the
terms and conditions of the limited product warranty as part of the
terms of thesale.