Instructions / Assembly

INSTALLATION INSTRUCTIONS
for Bi-Fold Doors (JII103)
4
A. Upper pivot pin
B. Guide for track
C. Snugger or slide guide
D. Lower pivot pin
E. Lower bracket
F. Track slide (optional)
G. Knob
H. Aligner
I. Track
J. Track bracket
Screws (not shown)
INSTALLATION FOR TYPE A1 - A4
3
PARTS INCLUDED
1. Using a hammer,
gently tap pivot pins
and guide into the
pre-drilled holes in
the locations shown.
2. Position overhead
track in the opening
with the open side
down and the bracket
end toward the jamb.
Center the track in
the  nished opening,
or allow at least 3/4"
between the track
and the front of the
 nished opening.
Secure the track with
the long pan head
screws through the pre-drilled holes until snug. If installing four panels
with two tracks, use a track bracket between the two ends in the center.
3. Position the lower
bracket on the  oor
in line with overhead
track. The bottom of
the bracket must rest
securely on the  oor
or carpet. Fasten to
the jamb and  oor
with a long  at head
screw through each
hole.
4. Place the upper pivot
pin in the hole in
the bracket and the
guide in the track (or
in the middle of the
slide guide between
the springs). Lift
the door assembly
slightly and drop the
lower pin into the
lower bracket slot.
5. Verify there is a 1/4"
clearance between
the pivot door and
the jamb. Four panel
assemblies should be
snug at the middle. If adjustments are necessary, door panels should
be folded, in some cases removed, to gain access to the adjustment
screws.
To adjust horizontally:
6. At the top, loosen
the screw in the top
pivot bracket and
move toward or
away from the jamb
until there is 1/4"
clearance. Retighten.
7. At the bottom, lift
assembly and move
the adjusting wheel
toward or away from
the jamb until doors
are plumb with jamb,
then lower into
bracket.
To adjust vertically:
8. Lift assembly slightly
until the adjustment
wheel clears the
slot in the lower
bracket. Rotate the
adjustment wheel to
the left to raise doors
or to the right to
lower them. Be sure
the teeth lock  rmly
into bracket when
 nished.
9. Snap the snugger
into the lead door end of the track, or between guides in a four door
installation.
SKIP to Section 8, “COMPLETE INSTALLATION.”
A
B
C
OR
OR
OR
OR
OR
D
E
F
G
H
I
J
Guide
Upper
pivot pin
Jamb
side
Lower
pivot pin
Lower
bracket
Bracket
Pin
Horizontal
adjustment
screw
Adjusting
wheel
1/4"