Instructions / Assembly

A
B
22 OR 24
11
JELD-WEN DesignGlide Barn Door Hardware System Installation
(JII-90003)
STEP 9: INSTALL AND ADJUST SOFT CLOSE
Attach soft close triggers.
1. Tighten anti-jump rods into the trigger assemblies ⑨ using supplied
3mm Allen wrench ⑩.
2. Slide door to center of track.
3. Slide triggers onto rail using the measurements/formulas in Table 5 as
guidelines.
a. Measurement 'A' is taken from edge closest to handle, as shown in
Figure 24.
b. Measurement 'B' is taken from the opposite edge of 'A'.
4. Secure triggers in place with set screws using supplied 3mm Allen
wrench.
Anti-Jump Rod
Figure 23. Trigger Installation
Kit Size Door Width (DW) A B
36" (72" Track)
30" ≤ DW < 32 1/2" = (2*Door Width) − 54 1/2" 1/2"
36" ≥ DW ≥ 32 1/2" 10 1/2" = Door Width – 28 1/2"
42" (84" Track)
36" ≤ DW < 38 1/2" = (2*Door Width) – 66 1/2" 1/2"
42" ≥ DW ≥ 38 1/2" 10 1/2" = Door Width – 34 1/2"
Figure 24. Trigger Alignment
Table 5. Trigger Locations
STEP 10: INSTALL TOP END CAPS
Using (2) #10 x 1" pan head screws ⑫, secure both end caps ⑪ in place.
Pan Head, #10 x 1" (2)
Figure 25. End Cap Installation
⑨
⑩
⑨
⑫
⑫
⑪