Instructions / Assembly

Assembly and Installation Instructions
for F-2500 Fiberglass Folding Patio Doors (JII-90008)
12
HARDWARE INSTALLATION
9
Install Hardware
1. Arrange hardware so that it matches the hardware layout within the
schematic on page 8.
2. To avoid damage to the rollers, clean all debris from the head and
silltrack.
3. Locate the cut out near
the end of the sill track
and insert the properly
handed Directional
Carrier Set (two wheel)
- Box 3. Carriers should
be positioned so that
the tapered wheels face
towards the interior and
the horizontal wheels face
towards the exterior.
4. Insert the properly handed
Lower Wall Pivot - Box1.
The hinge should be
inserted so that the heel,
with the two screw holes,
is positioned towards
the interior of the sill
track. Slide all the way
againstthejamb.
NOTE: The hardware in
box1 includes two plastic
housings for the Lower
Wall Pivot (one for a left-
hand door and one for a
right-hand door). Make sure
the correct plastic housing
is used according to the
handing of the door.
Secure the Lower Wall
Pivot - Box 1 to sill track
with two #6x1"screws.
Apply the aluminum sill
cover plate on top of the
Lower Wall Pivot - Box1
and secure with two
#8x3/8" screws.
5. Locate the cut out near the
end of the head track and
insert the Top Directional
Guide - Box 3.
NOTE: Partial removal of
the head jamb weatherstrip
(just past the cutout in
the head jamb) will assist
with the Upper Wall
Pivotinstallation.
6. Slide the Top Directional
Guide - Box 3 to the
opposite end of the
headtrack.
7. Install the Upper Wall
Pivot - Box 1. Align the
metal hinge plate with the
plastic housing and secure
the hinge to upper track
with four #6 x 1" screws.
8. Press the weatherstrip back
into the headtrack.
Cutout
Lower
Pivot Cover -
Box 1
Cutout
Weatherstrip
Top
Directional
Guide - Box 3
Upper Wall
Pivot -
Box 1
Weatherstrip
Head
Exterior
Exterior
Exterior
Exterior
Directional
Carrier Set -
Box 3
Lower Wall
Pivot - Box 1
Sill