Instructions / Assembly

Assembly and Installation Instructions
for F-2500 Fiberglass Folding Patio Doors (JII-90008)
13
INSTALL PANELS
10
Install Panels
Study the overall door conguration before installation. Begin panel
installation from the pivot panel. Panels are labeled “Pivot Panel” and
”Handle Panel”.
NOTE: Some hinge screws
are pre-installed in the edge
of the panels that have
ush bolts. These screws
are shorter than the other
hinge screws and must
be removed to install the
hinge and then re-installed
in the same location. This
is to eliminate interference
between the hinge screws
and ushbolt.
PIVOT PANEL: Installation of Wall Pivot Hardware - Box 1
1. Install Lower Wall Pivot
Hinge Leaf - Box 1 on
lower end of the panel with
provided #10x1 1/2" at
headscrews.
2. Hold the door in the vertical
position. Lift, align and
then set the Lower Wall
Pivot Hinge Leaf - Box 1
onto the Lower Wall Pivot
Pin - Box 1 installed into
the sill. Ensure the panel does not make contact with the head of the
door frame during installation. With the door panel supported, rotate to
the fully openedposition and hold until the upper wall pivot hinge leaf
issecured.
3. Slide the Upper Wall Pivot
Hinge Leaf - Box 1 on the
Upper Wall Pivot. Secure the
Hinge Leaf to the edge of
the pivot panel.
HANDLE PANEL: Installation of Directional Carrier Hardware - Box 3
1. Hold the pivot door panel in the open position. Place the handle panel
next to the pivot panel.
2. Make sure the center Pull Handle - Box 2 is to the inside. Secure
Hinges - Box 2 with the provided #10 x 1 1/2" at head screws.
3. Working from the interior, attach the pivot panel to the directional
hardware installed in the frame Top Directional Guide - Box 3 and the
Directional Carrier Set (two wheel) - Box 3.
Handle
panel
(2nd)
Handle
panel
Pivot
panel
(1st)
Pivot
panel
Hinge with
4 pre-drilled
holes
Hinge leaf with
3 pre-drilled
holes
Interior side shown
Exterior side shown
Panel
Lower wall
pivot hinge
leaf
Lower wall
pivot pin
Upper
wall pivot
Interior
Screws into
wood rst
1
1
2
2
Hinge
screw
Top Directional Guide -
Box 3
Directional Carrier Set
(two wheel) - Box 3
PIVOT PANEL: Installation of Intermediate Hinges - Box 2
1. Attach the hinges to the pivot panel with the provided #10x1 1/2"
at head screws. Use the 3 pre-drilled holes on the pivot panel to align
the hinges (the handle panel will be pre-drilled to accept the remaining
hingeleaves).
NOTE: Make certain that the countersunk holes for the screw heads on
the hinge leaf are facing toward the exterior.
FOR OPTIONAL HARDWARE ONLY!
Please reference the Optional Hardware Installation section on page 15. The borehole for the ball catch will have to be drilled prior to
installingthepanels.
Ball Catch