Instructions / Assembly

Installation Instructions
for Siteline
®
Wood/Clad Wood Double Hung Pocket Windows (JII-90012)
3
Safety
• Read and fully understand ALL manufacturer’s instructions before
beginning. Failure to follow proper installation instructions may result in
the denial of warranty claims for operational or performance problems.
• DO NOT work alone. Two or more people are required. Use safe
lifting techniques.
• Use caution when handling glass. Broken or cracked glass can cause
serious injury.
• Wear protective gear (e.g., safety glasses, gloves, ear protection, etc.).
• Operate hand/power tools safely and follow the manufacturer’s
operating instructions.
• Use caution when working at elevated heights.
• If disturbing existing paint, take proper precautions if lead paint is
suspected (commonly used before 1979). Your regional EPA
(www.epa.gov/lead) or Consumer Product Safety Commission ofces
provide information regarding regulations and lead protection.
Window Handling
• Heed material manufacturer’s handling and application instructions.
• Protect adhesive surfaces from dirt, moisture, direct sunlight and folding
over onto themselves.
• Handle in a vertical position; DO NOT drag on the oor.
• DO NOT put stress on joints, corners or frames.
• Store in a vertical, leaning position to allow circulation; DO NOT stack
horizontally.
• Ensure the storage area is dry, well-ventilation and protected from
exposure to direct sunlight.
• Only install into vertical walls when conditions and sheathing are dry.
IF INJURY OCCURS, IMMEDIATELY SEEK MEDICAL ATTENTION!
SAFETY AND HANDLING
MATERIALS AND TOOLS
JELD-WEN exterior window and door products should be installed in
accordance with JELD-WEN’s recommended installation and ashing
directions, which are shipped with the products or can be found
on our website: www.jeld-wen.com. NOTE: When using ashing,
spray adhesive/primer, sealant and foam products, we recommend
using the same manufacturer and verifying compatibility. It is the
End User’s responsibility to determine if dissimilar materials are
compatible with the substrates in the application.
Needed Materials
• Sealant: An exterior grade (High-Performing, Low VOC) sealant
is recommended for installation practices. Check with the sealant
manufacturer for color-match options and paintability.
• Polyurethane Low-Expansion Window and Door Foam: A low-
expansion, polyurethane window and door foam is recommended for
installation practices. Avoid using moderate to high-expansion products
as operational issues or damage may occur.
• Backer rod 1/8" larger than the widest portion of the gap (used in
conjunction with sealant bead).
Needed Tools
• Tape measure
• Level
• Hammer
• Utility knife
• Screwdrivers (driver with
#2 Phillips and at blade)
• Putty knife/Small pry bar
• Drill with bits
• Reciprocating saw
(for exteriorinstall)
• Caulking gun
Drilling, sawing, sanding or machining wood products
can expose you to wood dust, a substance known to
the State of California to cause cancer. Avoid inhaling
wood dust or use a dust mask or other safeguards
for personal protection. For more information, go to
www.P65Warnings.ca.gov/wood.
Parts Included
• 6 - 12 #8 x 3" installation screws
(not all may be needed for any giveninstallation)
• 1 - shim packet; 2 - shim packets for non-operating units
• Trim Kit - optional