Instructions / Assembly

Installation Instructions
for Siteline
®
Wood/Clad Wood Double Hung Pocket Windows (JII-90012)
5
The pivot pin can scratch/mar the cladding/wood when
removing or reinstalling thesash.
Lower Sash Removal:
• Unlock and raise sash upward
approximately 6 inches.
• Retract both tilt latches and
rotate the sash 90 degrees to
the main frame.
• Lift one side of the sash
upward until the pivot pin
clears the jamb liner.
• Repeat for the other side.
• Set sash aside in a safe and
drylocation.
Upper Sash Removal:
• Drop the sash approximately
12inches.
• Repeat steps above.
Exterior Install
90º
Sash
Head Parting Stop Removal:
• Initially dislodge the parting
stop by pulling/prying
downward at one end of
thestop.
• Repeat the process of pulling/
prying downward until you
have reached the other end of
the stop.
• Once fully removed set aside in a safe and dry area.
Jamb Liner Filler Removal:
• Remove the jamb liner ller by
using a small pry bar or your
thumb and ngers.
• Starting at the bottom of the
jamb liner, insert the pry bar
(or thumb and ngers) into
the jamb liner channels and
pry on the vinyl backing of the
ller strip.
• Repeat the steps above for
the opposite jamb liner and
place ller(s) in a safe and
drylocation.
Head parting stop
Jamb
liner
ller
Filler
Vinyl backing
Wood component
Double Hung Pocket Installation
NOTE: This unit should be fastened through the head and side jambs. The
removal of both sash, the head parting stop and the jamb liner llers is
required prior to the installation.
NOTE: The jamb liner ller is a two-piece component. To avoid damage
to the wood component, remove ller by grabbing/prying on the vinyl
backing.
4
POCKET WINDOW INSTALLATION AND FASTENING