Instructions / Assembly

LEFT-HAND POCKET RIGHT-HAND POCKET
INTERIOR
INTERIOR
3P3T
2P2T
2P2T
1P2T
EXTERIOR
4P4T
6P4T
X
X
XX
XX
XX
XXX
XXX
XXXX
XXXX
XXXX
OXXXXO
4P3T
P
A
P
A
P
A
12
Installation Instructions
for Premium
™
Vinyl Multi-Slide Atlantic Exterior Pocketing Door Systems (V-4500)
(JII-90004)
Pocket Congurations
General Notes
• There are multiple congurations for a multi-slide unit. Please refer to
the table above to familiarize yourself with the system you may have.
NOTE: Labeling on the panel packaging material should indicate the
panel location within the conguration.
• All panels are to be installed with the roller adjustment holes to
theexterior.
• All panels will be installed from the exterior.
• The panel(s) that ride on the interior most track need to be
installedrst.
• Panels should be installed, so they overlap by 50%. This ensures the
interlocks will be positioned correctly and allow for proper engagement
during normal operation.
• Head panel blocks are required to be attached to the head of the door
frame for units rated PG35 and higher (refer to “Install of Head Panel
Blocks” section for more detail).
• Panels with a handle set will be installed into the exterior most tracks.
A – Active Panel
P – Passive Panel (Astragal attached to the edge of the panel)
7
PANEL INSTALLATION
INSTALL FRAME (CONTINUED)
6
8. Apply the 5/16" weatherstrip pads
below the hook strip in a vertical
manner. Run the weatherstrip pad
from the bottom edge of the hook
strip to the horizontal wall of the
sill track. NOTE: The weatherstrip
pad should be at least 1 1/4" wide.
9. Apply the 1" weatherstrip pad to the sill horizontally, adjacent to the
5/16" weatherstrip pad.
10. Repeat the steps above for the head track.
11. Make sure the hook strip, panel and the sill are all integrated in a
weather-tight manner.