Instructions / Assembly

Side Jamb
Detail
Jamb screw
cover
Installation Instructions
for Premium
™
Vinyl Multi-Slide Atlantic Exterior Pocketing Door Systems (V-4500)
(JII-90004)
Please visit jeld-wen.com for warranty
and care and maintenance information.
Thank you for choosing
JII-90004 7/21
©2021 JELD-WEN, Inc. This publication and its contents are owned by or licensed to JELD-WEN, Inc. or its afliates or third parties, and are protected by copyright, trademark, and other laws. Unauthorized use
or duplication is prohibited. JELD-WEN reserves the right to change product specications without notice. Please visit our website at jeld-wen.com for current information.
All rights reserved.
COMPLETE INSTALLATION
Exterior
1. For continuous slabs and
dap out openings, apply a
discontinuous bead of sealant
at the sill to slab interface
(breaks in sealant are needed
to allow water to drain from
pan or dap out).
2. On the exterior of step-down
landings, install support trim
underneath the door frame
sill where it extends past the
landing. Position trim snugly
against the bottom of the sill nose.
Interior
1. Where applicable, create a continuous air seal on the interior between
the nished opening and the frame with low expansion foam or
backer rod andsealant.
After Installation
• Protect recently installed units from damage by covering the unit
with plastic.
• Remove protective lm (if applicable) on glass within six months.
• Apply head and side jamb screw covers. NOTE: If applicable, cut down
head jamb screw covers to t in-between the head panel blocks.
8
Screens
• A typical Pocket Door System does not allow for the use of a standard
rolling screen.
• If a retractable screen kit has been purchased for this door unit refer to
the instructions that come with the retractable screen kit. Installation of
a retractable screen system is not covered in this document.