Instructions / Assembly

11
8
9
SLAB REMOVAL AND INSTALLATION
Assembly and Installation Instructions
for Smooth-Pro
™
F-4500 Fiberglass Folding Wall System (JII-90076)
TITLE 1REMOVE PROTECTIVE FILM AND FINISHING (CONTINUED)
Make Final Adjustments - If Necessary
1. The wall system may need adjusting once installed. Slide the slabs into
the closed position and engage the handles to secure the slabs.
2. Upper and lower Wall Pivot Hinges adjust horizontally using a #3
Phillips head screwdriver. Clockwise rotations will move the slab away
from the jamb; counterclockwise will move the slab toward the jamb.
Adjust as necessary to achieve a consistent reveal across the opening.
3. Lower Wall Pivot Hinge and Directional Carrier Sets adjust vertically.
Insert a at-head screwdriver into the slot to release the spring and
turn the collar with a 14 mm open-ended wrench. One rotation will
provide approximately 1/16" adjustment. Rotation to the right will
raise the slab and rotation to the left will lower the slab. Adjust as
necessary to achieve a consistent reveal across theopening.
4. Open and close the wall system to check for alignment and smooth
operation.
Vertical
Adjustment
Nut
Release
Spring
Interior side shown
Horizontal
adjustment screw
Head
Horizontal
adjustment screw
Vertical
Adjustment
Nut
Sill
Single
hinge leaf
Bar
clamps
Wood Block
Slab Removal
Individual slabs are heavy. To avoid injury, use at least
3-people to remove. The slabs MUST be supported at
all times.
1. Prior to removing the wall system from the pallet. Unlock and fully
open the slabs to gain access to the hinges.
2. Use a putty knife to assist with the removal of the sweep
weatherstripping from under each slab.
3. Support the slabs with a wood block spanning the length of both
slabs and apply two bar clamps.
4. Remove the fasteners from the hinge leaf with 3 pre-drilled holes
(single hinge leaf) from the top and bottom hinges. NOTE: The hinges
will remain on the opposite slab.
5. Move to the interior of the wall system and remove the astragal cover
to expose the directional carrier fasteners.
Astragal
cover