Instructions / Assembly

©2023 JELD-WEN, Inc. This publication and its contents are owned by or licensed to JELD-WEN, Inc. or its afliates or third parties, and are protected by copyright, trademark, and other laws. Unauthorized use
or duplication is prohibited. JELD-WEN reserves the right to change product specications without notice. Please visit our website at jeld-wen.com for current information.
All rights reserved.
Please visit jeld-wen.com for warranty
and care and maintenance information.
Thank you for choosing
JII-90076 6/23
TITLE 1
9
7. Repeat steps for the bottom directional carrier. NOTE: A small
wooden wedge or pry par can be used to support the slab during the
removal of the lower hinge.
8. Remove the bar clamps and set the slab aside in a safe location.
9. Locate the fastener locations on the upper and lower wall pivot
hinges on the opposite slab and remove. NOTE: Support the pivot
hinge leaf when removing the screws. The hinge leaf and the hinge
post are two separate pieces.
Assembly and Installation Instructions
for Smooth-Pro
™
F-4500 Fiberglass Folding Wall System (JII-90076)
10. The slab will now be free from the hinges. Set aside in a safe location.
11. For 2 + 1 Wall Systems ONLY, repeat the process to remove the
remaining slab.
Slab Installation
1. Follow the slab removal steps in reverse.
2. Tighten all screws till snug – DO NOT overtighten.
6. Remove the directional
carrier fasteners and slide the
directional carrier out from
under the astragal.
SLAB REMOVAL AND INSTALLATION (CONTINUED)
Directional
carrier
Directional
carrier
Directional
carrier
screws
Upper
pivot slab
hinge