Instructions / Assembly

9
6
Top track
fastener locations
Assembly and Installation Instructions
for Smooth-Pro
™
F-4500 Fiberglass Folding Wall System (JII-90076)
FASTEN PRODUCT (SIZE AND SPACING)
Embedment must be a minimum of 1 1/4" into the
structural framing. Fastener (anchor) heads must be ush.
1. Fasten the head jamb
through the pre-drilled
hole locations using the
provided installation
fasteners. NOTE: A shim
is required at each
fastening location to
prevent frame deection.
Pre-drilled
hole
Sealant
Shim
Sill
Interior
Exterior
Sill Pan
Rough
Opening
Sealant
Fasteners through the sill will breach the sill pan
ashing. Following the sealant application steps
outlined below is imperative.
• Apply sealant to the threads of the fasteners. Apply additional
sealant into and around the pre-drilled hole.
• Seat the fastener until the head is ush with the frame.
• Apply sealant to the fastener head, ensuring the head is sealed to
the frame.
2. Apply sealant and fasten the
sill through each pre-drilled
hole location (located beneath
the rubber sill track seal).
15"
15"
3. Unlock and open the slabs to gain access to the pre-drilled fastener
locations behind the side jamb weatherstrip.
4. Fasten the side jamb at the
pre-drilled locations.
NOTE: DO NOT pinch or
rip the weatherstrip on the
side jambs.