Installations Sheet

4
■ A UL listed or CSA approved conduit connector
must be provided.
■ If the house has aluminum wiring, follow the
procedure below:
1. Connect a section of solid copper wire to the
pigtail leads.
2. Connect the aluminum wiring to the added section
of copper wire using special connectors and/or tools
designed and UL listed for joining copper to aluminum.
Follow the electrical connector manufacturer’s recommended
procedure. Aluminum/copper connection must conform with
local codes and industry accepted wiring practices.
For power requirements, refer to the following table:
Voltage Microwave With Convection Oven
120/240 VAC 19.9 A/3250 W
120/208 VAC 19.9 A/3250 W
INSTALLATION INSTRUCTIONS
Spacer Kit Installation
NOTES:
■ The microwave oven spacer kit allows the microwave oven
to be installed in an 17
7
/
16
" to 17
7
/
8
" (44.1 cm to 45.3 cm)
maximum cutout height.
■ If your cabinet cutout height is more than 17
7
/
16
" (44.1 cm),
you must install the spacer kit. Proceed to “Assemble
Spacer Kit.”
■ If your cabinet cutout height is less than 17
7
/
16
" (44.1 cm),
you do not have to install the spacer kit. Proceed to
“Prepare Built-In Microwave Oven.”
Assemble Spacer Kit
1. Attach the bottom vent to spacer bars using four
3
/
8
"
hex-head washer screws.
NOTE: Spacer bar flanges should be facing out.
Install Spacer Kit
1. Center assembled microwave oven spacer kit against lower
front edge of the cabinet cutout.
2. Using an
1
/
8
" (3.2 mm) drill bit, drill through the mounting
holes in the spacer bars to create pilot holes.
3. Attach the assembled spacer kit to the cabinet using four
3
/
4
"
flat-head screws. Do not overtighten screws.
Prepare Built-In Microwave Oven
1. Locate existing wiring to avoid drilling into or severing wiring
during installation.
2. To avoid floor damage, set the microwave oven onto
cardboard prior to installation. Do not use handle or
any portion of the front frame for lifting.
3. Remove the shipping materials and tape from the
microwave oven.
4. Remove and set aside racks and other items from inside
the microwave oven.
5. Remove the hardware package from inside the bag
containing literature.
6. Move the microwave oven and cardboard close to the
microwave oven’s final location.
A
B
C
D
D
A. Bottom vent
B. Spacer bar flange
C. Spacer bars
D.
3
/
8
" hex-head washer screws
A
B
A.
3
/
4
" flat-head screws
B. Spacer kit assembly
WARNING
Excessive Weight Hazard
Use two or more people to move and install
microwave oven.
Failure to do so can result in back or other injury.