5/11 P8500 Models CC PEP eee Sate of Agonists For Future Assistance... Safety Instructions Using Your Cook top .. Cook top at a Glance Setting the Controls Heat Settings Operating During Power Failure Lo Flame Adjustment Using the Griddle (select mode.
/ For Future Assistance PEEL trees Congratulations on your choice of a Jenna-Air gas cook top. Your complete satisfaction is very important to us. Read this user’s guide carefully. Iris intended to help you operate and maintain your new cook top. In addition, you will find a booklet entitled “Cooking Made Simple.” It contains information on selecting cookware, pan sizes and heat setting recommendations. Save time and money. Check the “Before You Call” section of this guide.
IMPORTANT SAFETY INSTRUCTIONS 2 PREEN EE PEEP ELE Eee ee Read before operating your cook top All appliances regardless of the manufacturer have the potential through improper or careless use to create safety problems. Therefore the following safety precautions should be observed: Be sure your appliance is properly installed and grounded by a qualified technician. . Never use your appliance for warming or heating the room. This warning is based on safety considerations. .
J IMPORTANT SAFETY INSTRUCTIONS tt tL te seer eee ae 23. A faint gas odor may indicate a gas leak. Ifa gas odor is detected, shut off the gas supply to the cook top. Call your installer or local gas company to have the possible leak checked. Never use a match or other flame to locate a gas leak. 24. Flame size should be adjusted so it does not extend beyond the edge of the cookware. This instruction is based on safety consideration. 25.
Cook top at a Glance There are three models included in this guide. Using Your Cook top 4 TEE PILE EEE IEEE ee + Model CCGP2820P is 48" and has six burners and a griddle. Optional backslash Model A509S. + Model CCGP2720P is 36” and has four burners and a griddle. Optional backslash Model IX T9027AAP. + Model CCGP2420P is 30” and has four burners. Optional backslash Model JXT9024 AAP. MODEL CCGP2820P 0 OQ ODOM MODEL CCGP2720P MODEL CCGP2420P NOTE: BTU ratings will vary when using LP gas. 1.
J Using Your Cook top tL ttt tts baa, Setting the Controls Your cook top has sealed gas burners with automatic re 1f the burner flame should go out, the system will autos spark to reignite the burner. -ignition. 1. Place a pan on the burner grate. (To preserve the grate finish, donor operate the burners without anon the grate to absorb the heat from the burner flame.) 2. Push in knob and turn immediately counterclockwise to the Lite setting until burner ignites.
HPO eee tees Lo Flame Adjustment This appliance has been shipped from the factory with Lo and Med flame sensing adjusted for use with natural gas and average installations. There is a wide variety of conditions caused by altitude and gas mixtures controlled by utility companies which will vary and affect the gas flame and performance. Adjustments should be made at time of installation. If conditions change, follow the procedures outlined below to adjust the Lo setting. 1.
OR III EES TESTIS / Care and Cleaning ELL ELLIE Eee Be sure all controls are OFF and all cook top parts are cool before cleaning. # Remove knobs in the OFF position by pulling each knob straight out. Never use a metal blade to pry knob off. + Wash in dishwasher or in warm, soapy water. Do not soak or use abrasive cleaners such as steel wool pads. Rinse and dry. + Replace knobs, matching the flat part of the knob opening with the flat part of the shaft. Make sure knobs are in the OFF position.
TELLS EEE EEE EE EEE LIE Care and Cleaning 8 Cleaning he Chart -continued © igs rats -coming ce 4 Light Soil ~— Wash them in hot, soapy water, rinse and dry. # Moderate Soil — Clean with a soap—filled, nonabrasive, plastic pad or Cook top Cleaning Creme* (Part # and a sponge. If soil remains, reapply Cook top Cleaning Creme. Cover with 4 damp paper towel and soak for 30 minutes. Scrub again, rinse and dry.
9 Before You Call for Service PEPS EEE EEE E EEE Check the following list to be sure a service call is really necessary. If surface burner fails to light: # check to be sure unit is properly connected to power supply. # check for a blown circuit fuse or a tripped main circuit breaker. # check to be sure burner is correctly rated for your type of gas. # check to be sure burner ports or ignition ports are not clogged.
III / / Warranty TEPEE EEE EEE EEE EEE EEE EY reo, JENNY-AIR COOK TOP WARRANTY Full One Year Warranty Parts and Labor For one (1) year from the original retail purchase date, any part which fails in normal home use will be repaired or replaced free of charge.