Manual

Options At A Glance Additional Information
Heating Options Adding a Forgotten Item
(Located on buttons on the left side of the panel.)
For best cleaning, the forgotten item should be added early
FAN DRY HEAT improves drying results by turning the in the cycle.
heating element on during a portion of fan dry.
1. Unlatch the door and wait until the sound of circulating
FAN DRY AIR turns the heating element off during the water stops.
fan dry portion of the cycle. Towel drying of some items
may be necessary. 2. Open the door and add the item.
3. Close and latch the door. The cycle will continue at the
Note: With either dry option, it is normal to notice point it was interrupted.
vapor coming out of the vent area.
ACCU TEMP checks the main wash and final rinse water C 1e a n i n g
temperatures and will extend the heating and water circu- Clean the control panel and front panels with a lightly
lation until proper water temperature is reached, dampened cloth. Dry thoroughly. Do not use abrasives or
SANI WASH (Select models only) turns the heating ele- sharp objects on the panel. They can damage it.
ment on during all wash and rinse portions of the cycle. It The inside normally takes care of itself. Occasionally
checks the main wash and final rinse water temperatures check the tub bottom for any large pieces which may have
and will extend the heating and water circulation until collected. Periodically clean the edge of the door liner and
proper water temperature is reached. This option does not gasket if any food spills are noticed.
sanitize the dishes.
To remove any odor, try one of the following:
RESET (Select models only) can be pressed to cancel all , Put baking soda in both cups. Select the normal cycle
heating options, and let the water circulate for about 10 minutes. Unlatch
the door and let it sit overnight. Then relatch the door
POTS & PANS (Select models only) adds water temper-
and let the cycle finish.
ature checks to the main wash and final rinse for proper
cleaning and drying results. , Select the Normal cycle and let the dishwasher fill with
water. Then open the door and pour 1 cup of chlorine
bleach into the bottom of the dishwasher. Latch the door
Indicator Lights
(select models) and let it complete the cycle.
, Try a lemon scent detergent and/or rinse aid to help peri-
ON - The On light will glow during all washes, rinses and odically freshen the dishwasher interior.
the drying periods.
, Run the dishwasher more frequently. Use the Rinse &
DELAY START- The Delay Start light will glow during Hold cycle (if available) to remove any food soil that
the Delay time period. It will go off when the dishwasher
may cause an odor.
starts.
CLEAN - The Clean light will glow after the drying peri- S t O r i n g
od is completed as a reminder that the dishes have. gone
through a wash and dry cycle. It will remain lit until the If your dishwasher will be in storage or an unheated area
dial is manually turned to the Off position, exposed to freezing temperatures:
_[_ HEAT DELAY - The Heat Delay light indicates the , Clean the dishwasher as explained above.
cycle is being extended to heat the water to the proper tem- , Operate the drain portion twice to ensure most of the
perature, water is removed. Most dishwashers begin each cycle
with a drain. For touch control models, press the
Drain/Off pad.
, Disconnect the electrical supply and prop open the door.