Owner's Manual

5
BEFORE USING THE OVEN
IMPORTANT: Complete the following steps before oven is used
for the first time.
1. Open the oven door, remove the accessories and make sure
that the oven is empty.
2. Rinse the water container with tap water (no detergents) and
then fill it to the “MAX” mark with fresh tap water. Slide the
water container into its compartment until it is firmly seated in
place.
3. Run the Calibration function. See “Calibrate” in the
“Maintenance Functions” section.
ELECTRONIC OVEN CONTROL
Control Panel
The control panel houses the control menu and function controls.
The control keypads are very sensitive and require only a light
touch to activate.
For more information about the individual controls, see their
respective sections in this manual.
The functions described in this section will work only if the oven
is On. To turn the oven On, press ON/HOME.
Electronic Oven Display
When power is first supplied to the oven, the display will prompt
you to set the Language and 24-hour clock. After a power failure,
the clock will flash and will need to be reset. See “Language” and
“Time” in this section.
This oven has a number of functions that can be adjusted to your
personal taste. See the appropriate section in this manual for the
setting you want to adjust.
On/Off/Pause
The oven can be turned On or Off or paused using the ON/HOME
button. A function can also be paused by opening the oven door.
When the oven is On, all buttons function normally, and the
24-hour clock is not displayed. When the oven is Off, only the OK
button will work. The 24-hour clock will be displayed.
Settings
You can control several settings through the Settings Menu:
Temperature Units, Language, Time, Display Brightness, Signal
Volume and Eco Mode.
To access the Settings Menu, press the up or down buttons until
“Settings” is selected on the display, then press OK to confirm.
Language
The language must be set on the display after power is supplied
to the oven.
To Set the Language:
1. Press ON/HOME.
2. Press the up or down buttons until “Settings” is selected on
the display, then press OK to confirm.
3. Press the up or down buttons until “Language” is selected on
the display, then press OK to confirm.
4. Press the up or down buttons until the desired language is
selected on the display, then press OK to confirm.
5. Press BACK to exit the settings function when you are done.
A. Cancel
B. On/Home
C. Digital display
D. Up/down - to scroll up/down or adjust to
higher/lower values
E. Start (control lock hold 3 sec)
F. Ok - to confirm setting
G. Back - to return to the previous screen
H. Most used - 10 most used functions
B
C
A
D
E
GH F