Installation guide

3 Connect drain hose
Connect drain hose to waste tee or waste disposer
using one ofthe following options:
* Option A, Waste disposer — no airgap
* Option B, No waste disposer —no.air. gap
* Option -C,; Waste disposer — with air gap
* Option D,-No waste disposer —with:air-gap
IMPORTANT: The drain hose connection of the disposer or a
waste tee must be made before the drain trap and at least 20”
(50.8 cm) above the floor where the dishwasher will be installed.
Helpful Tip: To reduce vibration of the hose, keep the hose away
from the floor.
Black end
2.
Connect black end of drain hose to
waste tee and cut if needed.
NOTE: Do not cut ribbed section.
Attach black end of drain hose to
waste tee with a large silver drain
hose clamp (provided). Use pliers to
squeeze clamp open and move into
position. lf the drain hose was cut,
use a 1%" to 2" (3.8 to 5 cm) screw-
type clamp (not provided).
Option C, Waste disposer - with air gap
Option A, Waste disposer — no air gap
Waste disposer — no air gap
SE pe << Large silver
drain hose clamp.
Disposerink
1. Using a hammer and screwdriver,
knock plug into disposer.
2. Use needle-nose pliers to remove
plug.
3. Attach drain hose to disposer inlet
with large silver drain hose clamp
(provided). Use pliers to squeeze
clamp open and move into position.
a, ~Disposer.in
- Screw-type clamps hh
Waste disposer — with air gap |
Large silver drain
} hose clamp
Rubber hose
connector
Drain hose
Drain trap
ir gap
Large
silver
drain hose clamp ~
No waste disposer —noa
10
Using a hammer and screwdriver,
knock plug into disposer.
Use needle-nose pliers to remove
plug.
Connect black end of drain hose to
air gap and cut if needed.
NOTE: Do not cut ribbed section.
Attach drain hose to air gap with
large silver drain hose clamp
(provided). Use pliers to squeeze
clamp open and move into position.
If the drain hose was cut, use a 1%"
to 2” (3.8 to 5 cm) screw-type clamp
(not provided).
Use a rubber hose (not provided)
with screw-type clamps (not
provided) to connect from air gap to
disposer inlet.