Installation guide

2? | Remove panel and fastener
Using a flat-blade screwdriver, turn the plastic fasteners /% turn to
unlock them. Remove panel. Do not remove tech sheet from
access panel.
3 Remove terminal box cover
Using a %4" hex head socket, nut driver or Phillips screwdriver,
remove terminal box cover. Retain for later use.
Install strain relief
| t NV
Install a UL Listed/CSA Approved strain relief. Make sure screw
heads are facing to the left when tightening conduit nut. Strain
relief is provided with the power supply cord kit.
12
What type of electrical
connection will you use?
. Power Supply Cord:
~-Follow Option A instructions
Direct Wire:
. Follow Option B instructions
NOTE: If using Option B, proceed to “Determine Cabinet
Opening,” to continue with the installation of your dishwasher.
DF gon om, Ciera a game Con nite sen a g C™ spo grok GO gs, sgt pe, gm, gia rm,
Make Power Supply Cord Connection
Option A, Power Supply Cord:
Power Cord—Route cord
into terminal box
Route cord so that it does not touch dishwasher motor to lower
part of dishwasher tub. Pull cord through strain relief in terminal
box. Take notice when installing or removing the dishwasher in
order to reduce the chance of damaging the power supply cord.
Select UL Listed/CSA Approved twist-on wire connectors
(included with power supply cord kit) rated to connect your power
supply cord to 16-gauge dishwasher wiring.