Tech Sheet

FOR SERVICE TECHNICIAN’S USE ONLY

■ Errors stored in the memory will be displayed from the most recent

occurrence to the oldest.

■ The Fault (F) Wi-Fi LED turns ON and the knob LEDs ash the

corresponding number (#). Then the UI is blank for a half second before

displaying the Error (#) code.

■ There is a 1 second delay between each fault/error code (F# E#).

■ Errors will continue to be displayed until the mode is exited or the mode

times out.

■ If there are no additional errors in the memory (OR if there are no errors

at all), the speaker will tone 3 times and the rst error will be displayed

again.

NOTE: If the error (E) number is zero (“0”), then only the fault (F) number is

displayed for that code.

To clear: After review, the stored error codes can be cleared out or erased. To

clear all error codes, press the Start button once.