Tech Sheet

FOR SERVICE TECHNICIAN’S USE ONLY

Test Name Description Steps

TEST #6

RTD Left Oven

Temperature

Sensor

To check: RTD function is good.

Example:

■ F6E3

1. Unplug range or disconnect power.

2. Remove door and toe panel to access main control.

3. Verify that ALL connectors are inserted all the way into the main control.

4. Check connector J3 on the left control REB board. Make sure it is plugged in and fully seated.

If it is not, make the proper connection and go to step 8.

5. Disconnect the J3 connector and measure indicated temperature sensor resistance value of

the RTD from J3-1 and J3-2 from the harness side. The resistance values should read: Oven

Sensor(s) - Between 931 and 2869 Ω (approximately 1080 Ω at room temperature).

If the temperature sensor does meet the requirements, go to step 8.

6. Remove back panels and ensure the indicated temperature sensor is plugged in properly and

fully inserted. See “Component Locations” section.

If it is not, plug it into the connector and go to step 8.

7. Disconnect the RTD from the main harness and measure resistance from RTD connector. The

resistance values should read: Oven Sensor(s) - Between 931 and 2869 Ω (approximately 1080Ω

at room temperature).

If it’s out of range, the oven sensor is improperly functioning, and needs to be replaced.

8. Reassemble all parts and panels. Plug in range or reconnect power.

9. Wait 3 minutes before checking if there is an error.

If there is an error, go to service mode to check if the error code is F6E3 (Left Oven Over

Temperature Limit).

Strobe

Door Switch

Left Temp Sensor

Pressure switch