Tech Sheet

FOR SERVICE TECHNICIAN’S USE ONLY
2
IMPORTANT: Electrostatic Discharge (ESD) Sensitive Electronics
ESD problems are present everywhere. ESD may damage or weaken the electronic control assembly. The new control
assembly may appear to work well after repair is finished, but failure may occur at a later date due to ESD stress.
■ Use an antistatic wrist strap. Connect wrist strap to green ground connection point or unpainted metal in the
appliance
-OR-
Touch your finger repeatedly to a green ground connection point or unpainted metal in the appliance.
■ Before removing the part from its package, touch the antistatic bag to a green ground connection point or
unpainted metal in the appliance.
■ Avoid touching electronic parts or terminal contacts; handle electronic control assembly by edges only.
■
When repackaging failed electronic control assembly in antistatic bag, observe above instructions.
Table of Contents
OVEN COMPONENTS ........................................................................................................................................3
CONTROL KNOBS .............................................................................................................................................5
DIAGNOSTICS ....................................................................................................................................................8
FAULT/ERROR CODES & TROUBLESHOOTING STEPS ................................................................................12
DIAGNOSTIC TESTS .........................................................................................................................................17
STRIP CIRCUIT TABLE - 30" (76.2 CM) RIGHT OVEN ....................................................................................37
STRIP CIRCUIT TABLE - 18" (45.7 CM) LEFT OVEN ......................................................................................40
CONTROL BOARDS COMPONENT LOCATION ..............................................................................................42
PIN-OUT .............................................................................................................................................................46