Tech Sheet

23
Test Name Description Steps
TEST #7
Meat Probe &
Jack or Main
Oven Meat Probe
Short-Circuit
Meat Probe &
Jack or Left
Oven Meat Probe
Short-Circuit
Examples:
1. F3E3
2. F3E9
3. Can’t start meat probe cycle.
1. Unplug range or disconnect power.
2. Open console assembly to access the user interface.
3. Verify that all connectors are inserted all the way into the user interface board(s).
4. Check resistance of meat probe sensor, the resistance should read between 3,400 and 39,500Ω.
If it is out of range, the meat probe is improperly functioning. Replace probe and go to step 6.
5. Check connector J5 on the user interface board. Make sure it is plugged in and fully seated.
If it is not, make the proper connection and go to step 6.
6. Disconnect J5 connector from the user interface board. Measure resistance between J5-1 and
J5-2 and it should be open.
If it short-circuit, the user interface board is improperly functioning, change the user interface
board and go to step 7.
7. Insert meat probe into meat probe Jack. Disconnect the J5 connector and measure indicated
meat probe sensor resistance value from J5-1 and J5-2 from the harness side. The resistance
values should read between 3,400 and 39,500 Ω.
If the temperature sensor does meet the requirements, go to step 10.
8. Remove back panels and ensure the indicated meat probe jack harness is plugged in properly
and fully inserted. See “Component Locations” section.
If it is not, plug it into the connector and go to step 10.
9. Disconnect the meat probe jack cable from the main harness and measure resistance from probe
jack connector. The resistance values should read between 3,400 and 39,500 Ω.
If it’s out of range, check meat probe jack cable. If it is improperly functioning.
10. Reassemble all parts and panels. Plug in range or reconnect power. Use the app to start a meat
probe cycle (meat probe cycle can only start from the app).
11. Wait 3 minutes before checking if there is an error.
If there is an error, go to service mode or use the app to check if the error code is F6E3 (main
oven meat probe short-circuit) or F6E9 (left oven meat probe short-circuit).
PWR J4-1
ID J4-2
DATA J4-3
WRC RIGHT
GND J4-4
PWR J4-1
ID J4-2
DATA J4-3
WRC LEFT
GND J4-4
J5
1
Meat Probe
J5
1
Meat Probe