Tech Sheet

FOR SERVICE TECHNICIAN’S USE ONLY
24
Test Name Description Steps
TEST #8
Door Switch(es)
Check the door switch detection
function is good.
Examples:
1. F5E0
2. F5E2
1. Unplug range or disconnect power.
2. Wait 10 seconds then plug in range or reconnect power.
3. Wait for 20 seconds. Open the oven door. Move the knob to clean & clean positions, press the
start button. There should be no response (no tone, no start button light change) or start light
keeps slow ashing.
If there is a tone response, and the latch motor starts operation, go to step 5.
4. Move the knob to the Bake and Off positions. Close the door. Move the knob to clean & clean
position and press the start button. Check if the latch motor is functioning.
If there is a tone response, and the latch motor starts operation, the door switch test is passed.
5. Unplug range or disconnect power.
6. Remove the door and toe panel to access the main control.
7. Verify that ALL connectors are inserted all the way into the main control.
8. Use a multimeter to measure the resistance of the door switch input. For the main cavity door
switch, the inputs are P7-4 & P7-5 from the main ACU.
For the left cavity switch, the inputs are J3-6 & J3-7 from the left control board REB.
It should be open when the door is open and it should be shorted when the door is closed or
when the door switch is manually pressed and held.
If the resistance is correct, replace ACU or REB control. Reassemble all parts and panels. Plug in
range or reconnect power and go to step 1 to verify the door switch function again.
9. Remove back panel, check continuity of the door switch and electrical connections between the
control board and switch.
If continuity is not present, go to step 10.
10. Replace door latch motor assembly.
11. Reassemble all parts and panels. Plug in range or reconnect power and go to step 1 to verify the
door switch function again.
1
P7
Door Latch Switch Right
HES Signal
Strobe
Door Switch
HES Signal VDD
HES Signal GND
Door Latch Switch Left
1
J3
Strobe
Door Switch
Left Temp Sensor
Pressure switch
J3-6
J3-7