Instruction Sheet
CARE
1. Keep away from environments with excessive heat, humidity,
magnetism, and dust.
2. Replace the batteries when low with (2) 1.5 V AAA batteries
by removing the screw on the battery cover. Remove the
batteries when the probe is not used for an extended period
of time.
3. The probe can be cleaned with a soft cloth and neutral
detergent.
4. Wash the probe thoroughly after using and dry with a towel.
5. Keep the probe dry. Avoid getting any liquids into the probe
as this may affect the performance of the probe.
6. Keep out of reach from children.
7. It is recommended to keep the probe in temperatures of
-30°C ~ 250°C / -22°F ~ 482°F.
Avoid environments of extremely high temperatures and
extremely low temperatures as they may cause product
damage.
8. Press and hold the “Reset” button to reset the probe.
FCC STATEMENTS
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including
interference that may cause undesired operation.
Changes or modications not expressly approved by Ningbo
Kaitai Electronic Co., Ltd. for compliance could void the user’s
authority to operate the equipment.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
■ Reorient or relocate the receiving antenna.
■ Increase the separation between the equipment and receiver.
■ Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
■ Consult the dealer or an experienced radio/TV technician for
help.
This equipment complies with FCC and ISED Canada radiation
exposure limits set forth for an uncontrolled environment.
ISED Canada Statement
This device complies with Industry Canada’s license-exempt
RSSs. Operation is subject to the following two conditions:
1. This device may not cause interference; and
2. This device must accept any interference, including
interference that may cause undesired operation of the
device.
13 14