Installation guide

Notice To Installer
Follow accompanying instruction carefully.
Never use a metal blade to pry knob off. If knob
cannot be easily removed, tuck folds of a
dishtOwel unde r knob skirt and pUll upward with
steady, even pressure,
Preparation Of Countertop
The cutout in the countertop into which the appliance is to
be installed should be prepared according to the cutout
dimensions given on page 1 of these instructions.
CAUTION
CutoUt dimensions are critiCal: Dimension sI
must b,emeasured and cut accurately to within
+!!!6 (1!6 cm) to insure proper fit, J
Installation Of Appliance
1. Remove the cooktop from the carton and place it
upside down over two soft pads making sure control
knobs do not interfere with any surface.
2. Peel off the backing paper from one of the pieces of
foam tape provided with the unit and stick the adhesive
backed tape to the glass as close as possible to the
burner box along the left edge of the cooktop. Repeat
the process with the second piece of foam tape along
the right edge of the cooktop.
Glass_
\
Tape
Bottom View
Foam
Tape
,
Burner Box J
ART _ZI_-17_-O
Burner Box
\
' II Foam
_Li ape (Place as close as possible
to Burner Box along leftand
right side only).
3. Provide cutout in countertop as required per page 1.
4. Place unit in the cutout.
5. Make electrical wire connection to unit. Consult local
codes for proper power hook-up.
6. Test to insure control knobs operate all elements
properly.