Manual

Triple Element Q
(select models)
Off
The cooking surface has one triple L High
element located in the right front
position. This element can be used
for larger cooking utensils when the
triple element is chosen, or for _ _ 8
smaller pans when the single or dual
settings are chosen. To operate the
single element, push in the control High _\ 4
Low
knob and rotate to the left. To
operate the dual or triple elements,
make the selection with the rocker
switch and rotate the control knob to
the right.
(_ ©
Ultra Off Ultra
Low High
Custom Control
2
(select models)
The Custom Control Dual Element 3
offers two element sizes and is located 4 6
in the left front position. This element
uses an electronic sensor to constantly monitor and adjust
heat output for precise and consistent temperature control.
To operate, push in on the control knob and turn to the right
to control the small element, or push to the leftto control the
large element.
Warming Zone (:selectmodels)
Use the Warming Zone to keep cooked foods warm, such as
vegetables and gravies.
/
Press the Warm Zone pad to turn on the Warm
Zone
element, then press the Quickset pad for On / Off
HIGH or LOW. To turn off, press the Warm ..................
Zone pad once. An icon may light as a reminder
that the Warming Zone is in use.
Important:
• Never warm food for longer than one hour (eggs for
30 minutes:), as food quality may deteriorate.
• Do not heat cold food on the Warming Zone.
• Heat settings will vary depending on type and amount of
food. Always hold food at proper food temperatures. USDA
recommends food temperatures between 140°-170° F.
Notes:
° Use only cookware recommended as safe for oven and
cooktop use.
• Always use oven mitts when removing food from the
Warming Center as cookware will be hot.
• All foods should be covered with a lid or aluminum foil to
maintain food quality.
• Do not use plastic wrap to cover foods. Plastic may melt
on to the surface and be very difficult to clean.
Smoothtop Surface
Notes:
• Cooktop may emit light smoke and odor the first few
times the cooktop is used. This is normal.
° Smoothtop cooktops retain heat for a period of time
after the element is turned off. Turn the elements off
a few minutes before food is completely cooked and use
the retained heat to complete cooking. When the hot
surface light turns off, the cooking area will be cool
enough to touch. Because of the way they retain heat, the
smoothtop elements will not respond to changes in
settings as quickly as coil elements.
• In the event of a potential boilover, remove the pan from
the cooking surface.
• Never attempt to lift the cooktop.
• The smoothtop surface may appear discolored when it is
hot. On Frost models, the smoothtop will have a slight
pink or green tint. This is normal and will disappear when
the surface cools.
Not Surface Indicator Lights
The Hot Surface indicator lights are located next to the
elements. These lights indicate when the adjacent cooking
area is hot to the touch even after the control has been
turned off. The red light will remain on until the surface
has cooled.
Cooking Areas
The cooking areas on your range are identified by permanent
patterns on the smoothtop surface. For most efficient cooking,
fit the pan size to the element size.
Pails should not extend more than _/2to 7-inch beyond
the cooking area.
When a control is turned on, a glow can be seen through the
smoothtop surface. The element will cycle on and off to
maintain the preset heat setting, even on High.
For more information on cookware, refer to Cookware
Recommendations on page 12.
REGULAR
WARMING ZONE
REGULAR
ELEMENT
11
TRIPLE ELEMENT
(SELECT MODELS)
Tips to Protect the
Smoothtop Surface
Cleaning (see page 6 for more information:)
• Before first use, clean the cooktop.
• Clean your cooktop daily or after each use. This will keep
your cooktop looking good and can prevent damage.