Installation guide

ManualsBrandsJenn-Air ManualsCooktopOfficial Jenn-Air counter unit

30" (76.2 CM) AND 36" (91.4 CM)

GAS DOWNDRAFT COOKTOP

INSTALLATION INSTRUCTIONS

INSTRUCTIONS D’INSTALLATION DE LA TABLE

DE CUISSON À GAZ À ASPIRATION PAR LE BAS

DE 30" (76,2 CM) ET DE 36" (91,4 CM)

Table of Contents/Table des matières

COOKTOP SAFETY

IMPORTANT:

Installer: Leave installation instructions with the homeowner.

Homeowner: Keep installation instructions for future reference.

IMPORTANT :

Installateur : Remettre les instructions d’installation au propriétaire.

Propriétaire : Conserver les instructions d’installation pour référence ultérieure.

W10848427D

COOKTOP SAFETY ........................................................................ 1

INSTALLATION REQUIREMENTS .................................................3

Tools and Parts ............................................................................. 3

Location Requirements ................................................................3

Venting Requirements ..................................................................6

Venting Methods ..........................................................................7

Electrical Requirements ...............................................................8

Gas Supply Requirements ...........................................................9

INSTALLATION INSTRUCTIONS .................................................10

Prepare Cooktop ........................................................................10

Install Cooktop ...........................................................................11

Make Gas Connection ...............................................................12

Attach Cooktop to Countertop ..................................................13

Electronic Ignition System .........................................................13

Complete Installation .................................................................14

SÉCURITÉ DE LA TABLE DE CUISSON .....................................15

EXIGENCES D’INSTALLATION ...................................................16

Outillage et pièces ......................................................................16

Exigences d’emplacement .........................................................16

Exigences concernant l’évacuation ...........................................18

Méthodes d’évacuation .............................................................19

Spéciﬁcations électriques ..........................................................21

Spéciﬁcations de l’alimentation en gaz .....................................21

INSTRUCTIONS D’INSTALLATION .............................................23

Préparation de la table de cuisson ............................................23

Installation de la table de cuisson ..............................................24

Raccordement au gaz ................................................................25

Fixation de la table de cuisson au plan de travail......................26

Système d’allumage électronique..............................................27

Achever l’installation ..................................................................27

Summary of content (15 pages)

PAGE 1
30" (76.2 CM) AND 36" (91.4 CM) GAS DOWNDRAFT COOKTOP INSTALLATION INSTRUCTIONS INSTRUCTIONS D’INSTALLATION DE LA TABLE DE CUISSON À GAZ À ASPIRATION PAR LE BAS DE 30" (76,2 CM) ET DE 36" (91,4 CM) Table of Contents/Table des matières COOKTOP SAFETY.........................................................................1 INSTALLATION REQUIREMENTS..................................................3 Tools and Parts..............................................................................
PAGE 2
WARNING: If the information in these instructions is not followed exactly, a fire or explosion may result causing property damage, personal injury or death. – Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. – WHAT TO DO IF YOU SMELL GAS: • Do not try to light any appliance. • Do not touch any electrical switch. • Do not use any phone in your building. • Immediately call your gas supplier from a neighbor's phone.
PAGE 3
INSTALLATION REQUIREMENTS Tools and Parts Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. Tools needed Location Requirements IMPORTANT: Observe all governing codes and ordinances. When installing cooktop, use minimum dimensions given. ■■ It is the installer’s responsibility to comply with installation clearances specified on the model/serial/rating plate.
PAGE 4
Product Dimensions 30" (76.2 cm) Cooktop 36" (91.4 cm) Cooktop A A B B C C A. 21 / " (54.6 cm) B. 1931/32" (50.7 cm) C. Model/serial/rating plate location 1 2 A. 211/2" (54.6 cm) B. 1931/32" (50.7 cm) C. Model/serial/rating plate location A A C C B D B D E F A. B. C. D. 4 30" (76.2 cm) 49/64" (10.5 cm) 647/64" (17.1 cm) 185/16" (46.5 cm) H G E. 111/16" (4.3 cm) recommended minimum cabinet to motor clearance F. 1429/64" (36.7 cm) G. 1223/32" (32.3 cm) H. 2825/64" (72.1 cm) E A. B. C. D.
PAGE 5
Cabinet Dimensions Cutout Dimensions IMPORTANT: If installing a range hood or microwave hood combination above the range, follow the range hood or microwave hood combination installation instructions for dimensional clearances above the cooktop surface. A B A D C E F D H I B C J F L E N G H M K G I K J M A. 30" (76.2 cm) on 30" (76.2 cm) models 36" (91.4 cm) on 36" (91.4 cm) models B. Combustible area above countertop (shown by dashed box above) C. 30" (76.
PAGE 6
Venting Requirements IMPORTANT: This cooktop must be exhausted outdoors unless using the Duct-Free Filter Accessory Kit. See the “Venting Methods” section. ■■ Do not terminate the vent system in an attic or other enclosed area. ■■ Use a vent cap. ■■ Vent system must terminate to the outside. ■■ Use only a 6" (15.2 cm) round metal vent. Rigid metal vent is recommended. For best performance, do not use plastic or metal foil vent.
PAGE 7
Venting Methods Common venting methods are shown for a counter-mounted downdraft cooktop. The cooktop may be vented through the wall or floor. Option 1 - Roof Venting Option 2 - Wall Venting B Concrete Slab Installations - Exhaust Through Wall B A D F C N G M B L A A A. 6" (15.2 cm) round roof venting B. Roof cap A. 6" (15.2 cm) round wall venting B. Wall cap Option 3 - Venting Between Floor Joist Option 4 - Venting Behind Cabinet Kick Plate E K H I J A. Wall cap B. 6" (15.
PAGE 8
Calculating Vent System Length Example vent system Vent Piece 6" (15.2 cm) Round 45° elbow 2.5 ft (0.8 m) 90° elbow 6" (15.2 cm) wall cap 31/4" x 10" (8.3 cm x 25.4 cm) to 6" (15.2 cm) transition 6 ft (1.8 m) 2 ft (0.6 m) 5.0 ft (1.5 m) 0.0 ft (0.0 m) 4.5 ft (1.4 m) 6" (15.2 cm) to 31/4" x 10" (8.3 cm x 25.4 cm) transition 1 ft (0.3 m) 31/4" x 10" (8.3 cm x 25.4 cm) to 6" (15.2 cm) 90° elbow transition 5.0 ft (1.5 m) 6" (15.2 cm) to 31/4" x 10" (8.3 cm x 25.4 cm) 90° elbow transition 5.
PAGE 9
Gas Supply Requirements WARNING Explosion Hazard Use a new CSA International approved gas supply line. Install a shut-off valve. ■■ ■■ A 1/2" (13 mm) male pipe thread is needed for connection to the female pipe threads of the inlet to the cooktop pressure regulator. ■■ Do not kink or damage the flexible metal tubing when moving the cooktop. Must include a shut-off valve: Install a manual gas line shut-off valve in an easily accessible location. Do not block access to shut-off valve.
PAGE 10
INSTALLATION INSTRUCTIONS Prepare Cooktop 7. Using a 1/4" (6.4 mm) nut driver, screw in the six screws from the literature pack to attach plenum. 8. Remove access panel from plenum using a 1/4" (6.4 mm) nut driver and set aside. Decide on the final location for the cooktop. WARNING Excessive Weight Hazard Use two or more people to move and install cooktop. Failure to do so can result in back or other injury. IMPORTANT: Do not cut top of product packaging. This may damage the product. 1.
PAGE 11
13. Using a 1/4" (6.4 mm) nut driver, screw the electrical junction cover to the burner box with two screws. 3. Using two or more people, lift the cooktop from packaging foam and install the cooktop into the countertop cutout by tilting one end of the cooktop into the cutout, then lowering the other end into the cutout. NOTE: Make sure that the front edge of the cooktop is parallel to the front edge of the countertop.
PAGE 12
Make Gas Connection WARNING Complete Connection 1. Open the manual shut-off valve in the gas supply line. The valve is open when the handle is parallel to the gas pipe. A A. Closed valve B. Open valve Explosion Hazard Use a new CSA International approved gas supply line. Install a shut-off valve. Securely tighten all gas connections. If connected to propane, have a qualified person make sure gas pressure does not exceed 14" (36 cm) water column.
PAGE 13
Electronic Ignition System Initial Lighting and Gas Flame Adjustments This cooktop is equipped for electronic auto-reignition by means of a spark igniter located at the rear of each burner. The burners are designed to light at any valve rotation that admits sufficient gas flow to support a flame and to automatically relight following a loss of flame due to a draft or other adverse condition. This feature is provided only as a convenience.
PAGE 14
If the low flame needs to be adjusted: 1. Light one burner and turn to lowest setting. 2. Remove the control knob. 3. Hold the knob stem in the low position using a pair of pliers. Use an 1/8" (3.0 mm) flat-blade screwdriver to turn the screw located in the center of the control knob stem until the flame is the proper size. Complete Installation 1. Check that all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped. 2.