Installation guide

InstructionsTo Installer
1. Chamfer all exposed edges of decorative laminate to
prevent damage from chipping.
2, Radius corners of cutout and file to insure smooth
edges and prevent corner cracking. Recommend
1/4" or 3/8" diameter drill in each corner,
3. Rough edges, inside comers which have not been
rounded and forced fit can contribute to cracking of the
counter top laminate.
4. Countertop must be supported within 3" of cutout.
Minimum horizontal clearance between the edge of the
appliance and combustible construction extending from the
cookingsurface to 18" (45,7 cm) above the cooking surface
is:
15116"(2.38 cm) at rear
8" at sides
This is not the recommended clearance, but minimum
allowable clearance.
Nr Shutter Adjustment
This appliance is shipped from the factory with air shutters
adjusted for use with N=ural Gas. If further adjustment is
necessary, or to reset for use with LP, adjust air shutters as
follows:
Grill Burner and Surface Burner Cartridge Air
Shutters (SeeIllustrations"A" & "B")
The left hand air shuttercontrols the rear half of the burner.
The right hand shutter controlsthe front half. Access to air
shutters on the surface burner cartridge may be found
through openings on the bottom of the cartridge housing.
Slide air shutters backward or forward to increase or
decrease the size of the air opening. Air shutters fit snugly,
so a screwdriver blade may be required to make this
adjustment (see illustration).
Observe change in flame appearance as the air shutter is
moved. Adjustment is satisfactory when a cleady defined,
even blue flame results at the high flame setting. The snug
fit of the air shutter assures it will remain positioned
correctly.
Grill Burner Air Shutter end Surface Bumer
(if so equipped)
AIR
INSERT SCREWDRIVER
BLADE IN SLOT AND TWIST
WITH SLIGHT PRESSURE TO
ALLOW AIR SHUTTER TO
SLIDE EASILY
ILLUSTRATION "A"
On any burner, closingthe air shuttertoo far wiltcausethe
flame to become soft and yellow tipped. Opening the air
shutter too wide will causethe flame to blow away from the
burner ports. Proper adjustmentwill produce a sharp,clearly
defined, even blue flame.
-A{R SHUTTER
ILLUSTRATION "B"