Installation guide

TO CONVERTAPPLIANCEFOR USEWITH NATURALGAS
Propane Gas (LP) To Natural Gas
Conversion Instructions
If this appliance has been convertedfor use with LP Gas,
each of the following modifications must be performed to
convert the unit back to Natural Gas
'_Natur_GascOnverslonistobeperformed,bya
3e_.ir /Authorized Service Contractor (or
_,er:qua!ifiedagency) in accordancewiththe
__._s instructionsandallcodesand
_Ve_l=_metlts_ :-of ,the authority , having
_dsdtcti0p,' F_Um to follow instructions could
__i_ury rOrproperty damage. The
___o_ng t_ work_ornes
o , -
'__"RAJmv'GASrareSTeE
Models - JGD8130 & JGD8345 Series
Manifold - Natural Gas pressure required - 5" W.C.
Incoming Natural Gas pressure required to appliance
pressure regulator - 6" - 7" W.C.
Natural Gas input specified, Model JGD8130/JGD8345 -
36,000 BTU/hr / 56,000 BTU/hr.
A. Replace al!orificehoods- Perform steps 1through 4 on
page4 Locate the (4)four or (2) two Natural Gas hoods
(with small numbers stamped on their sides) saved
from the original Natural Gas unit. Page 4 Illustration
"E". The two hoods with .0520 (#55 orifice) stamped on
them are for the left front and left rear burners. The two
hoods with the .0550 (#54 odfice) stamped on them are
for the two right burners.
To make these conversion adjustments follow the
instructions and illustrations ("A" through "E") pages
3 and 4.
B. invert cap in appliance pressure regulator (see
Illustration "D"). With the appliance installed, the
appliance pressure regulator is located on the center
underside of the appliance at the inlet to the gas
manifold. Identify the type of appliance pressure
regulator on the unit and follow the instructionsin the
appropriate Illustration.
C. Adjust low flame setbng for each bumer. Follow the
instructions for burner low flame adjustment on page 4
to increase the simmerflame size.
®
JGD8345 (Shown)
TIEDOWN
BOLTON
EACHEND
GREA3E
CONTAINER
PRESSURE
REGULATOR
BLOWERCANBE
SWIVELED90o
INCHES
BURNER BTU/hr ORIFICE DIAMETER COLOR
Left Rear (LR) 8,000 #55 .0520 Brass
Left Front (LF) 8,000 #55 0520 Brass
Right Rear (RR) 10,000 #54 .0550 Brass
RightFront (RF) 10,000 #54 .0550 Brass
Center Rear (CR) 10,000 #54 .0550 Brass
Center Front (CF) 10,000 #54 .0550 Brass