Installing Oven Under Cooktop

ManualsBrandsJenn-Air ManualsHoodsJenn-Air JIC4536XS

CUTOUT DIMENSIONS FOR OVENS INSTALLED UNDER COOKTOP

IMPORTANT: Observe all governing codes and ordinances. Cooktop must be approved for use over an oven. See Cooktop Installation

Instructions for cutout dimensions. Center the cooktop cutout over oven cutout.

To avoid damage to your cabinets, check with your builder or cabinet supplier to make sure that the materials used will not discolor,

delaminate or sustain other damage. This oven has been designed in accordance with UL and CSA International and complies with the

maximum allowable wood cabinet temperatures of 194°F (90°C).

Approved Built-In Oven and Electric Cooktop Combinations

For the approved model number combinations refer to the undercounter label located on top of the oven chassis and on the

bottom of the cooktop burner box.

NOTE: For undercounter installation, it is recommended that the junction boxes for the oven and cooktop be located in the adjacent

right or left cabinet. A 1" (2.5 cm) minimum diameter hole should have been drilled in the upper rear right or left corner of the side wall

surface to pass the appliance cable through to the junction box.

W10373103B

A. 24" (61 cm) minimum cabinet depth

B. 25" (63.5 cm) countertop depth

C. Recommended oven and cooktop junction box locations

D. Allow

⁵⁄₈

" (1.6 cm) for oven trim to overlap on each side.

E. 27¾" (70.5 cm) recommended cutout height (will fit cutout height

from 27" [68.6 cm] to 29

¹⁄₁₆

" [73.8 cm])

F. 36" (91.4 cm) minimum cabinet height from floor to top of

countertop

G. 4

⁵⁄₈

" (11.7 cm) from floor

H. See Cutout Dimensions chart.

I. 31

³⁄₈

" (79.7 cm) from top of countertop to bottom of cutout

NOTE: 24" (61.0 cm) minimum cutout depth required.

CUTOUT DIMENSIONS

Oven Size Oven Cutout Dimension

27" (68.6 cm) 25¹⁄₂" (64.8 cm) recommended

30" (76.2 cm) 28½" (72.4 cm) recommended

(will fit cutout width from

28½" [72.4 cm] to 29" [73.7 cm])

Summary of content (8 pages)

PAGE 1
CUTOUT DIMENSIONS FOR OVENS INSTALLED UNDER COOKTOP IMPORTANT: Observe all governing codes and ordinances. Cooktop must be approved for use over an oven. See Cooktop Installation Instructions for cutout dimensions. Center the cooktop cutout over oven cutout. To avoid damage to your cabinets, check with your builder or cabinet supplier to make sure that the materials used will not discolor, delaminate or sustain other damage.
PAGE 2
Approved Built-In Oven and Induction Cooktop Combinations B A C C I F D E G H A. 24" (61 cm) minimum cabinet depth B. 25" (63.5 cm) countertop depth C. Recommended oven and cooktop junction box locations D. Allow ⁵⁄₈" (1.6 cm) for oven trim to overlap on each side. E. 27¾" (70.5 cm) recommended cutout height (will fit cutout height from 27" [68.6 cm] to 29¹⁄₁₆" [73.8 cm]) F. 36" (91.4 cm) minimum cabinet height from floor to top of countertop G. 3⁵⁄₈" (9.2 cm) from floor H.
PAGE 3
Approved Built-In Oven and Gas Cooktop Combinations C B A D D E N E F H G J I I K L M A. 24" (61 cm) minimum cabinet depth B. 1" (2.5 cm) clearance from the top of junction box to the bottom of the countertop C. 25" (63.5 cm) countertop depth D. Recommended grounded 120 volt outlet location for cooktop E. Recommended oven junction box locations F. 27¾" (70.5 cm) recommended cutout height (will fit cutout height from 27" [68.6 cm] to 29¹⁄₁₆" [73.8 cm]) G. Allow ⁵⁄₈" (1.
PAGE 4
Notes 4
PAGE 5
FOUR INSTALLÉ SOUS LA TABLE DE CUISSON - DIMENSIONS POUR L'OUVERTURE À DÉCOUPER IMPORTANT : Observer toutes les dispositions des codes et règlements en vigueur. La table de cuisson doit être homologuée pour l'utilisation au-dessus d'un four. Pour les dimensions de l'ouverture à découper, voir les “Instructions d'installation de la table de cuisson”. Centrer l'ouverture à découper pour la table de cuisson par dessus à l'ouverture découpée pour le four.
PAGE 6
Combinaisons table de cuisson à induction/four encastré (produits homologués) B A C C I F D E G H A. Profondeur de placard 24" (61 cm) minimum B. Profondeur du plan de travail 25" (63,5 cm) C. Emplacements recommandés pour le boîtier de connexion du four et de la table de cuisson D. Prévoir ⁵⁄₈" (1,6 cm) pour le chevauchement de la garniture du four, de chaque côté. E.
PAGE 7
Combinaisons table de cuisson à gaz/four encastré (produits homologués) C B A D D E N E F H G J I I K L M A. Profondeur de placard 24" (61 cm) minimum B. Dégagement de 1" (2,5 cm) du haut du boîtier de connexion au bas du plan de travaill C. Profondeur du plan de travail 25" (63,5 cm) D. Emplacement recommandé de la prise reliée à la terre de 120 volts pour la table de cuisson E. Emplacements recommandés du boîtier de connexion du four F.