Owner's Manual
Table Of Contents
- BUILT-IN OVEN SAFETY
- Built-In Oven Safety
- OVEN MAINTENANCE AND CARE
- General Cleaning
- Self-Cleaning Cycle
- Steam Clean (on some models)
- INSTALLATION INSTRUCTIONS
- REQUIREMENTS
- Tools and Parts
- Location Requirements
- Electrical Requirements
- INSTALLATIONS
- Prepare Built-In Oven
- Remove Oven Door(s)
- Positioning Oven Feet for Multiple Cabinet Cutout Heights
- Make Electrical Connection
- Install Oven
- Replace Oven Door(s)
- Complete Installation
- SECURITE DU FOUR ENCASTRE
- Securite du four encastre
- ENTRETIEN ET REPARATION DU FOUR
- Nettoyage general
- Programme d'autonettoyage
- Steam Clean (nettoyage a la vapeur) (sur certains modeles)
- INSTRUCTIONS D'INSTALLATION
- SPECIFICATIONS
- Outils et pieces
- Exigences d'emplacement
- Specifications electriques
- INSTALLATION
- Preparer le four encastre
- Enlever la/les porte(s) du four
- Positionner les pieds du four pour des ouvertures de decoupe dans l'armoire
- Raccordement electrique
- Installation du four
- Reinstallation de la/des porte(s) du four
- Achever l'installation
18
5. The bottom vent and bottom vent shield are shipped in the
foam packing at the top of the oven.
Long bottom vent trims are used when the oven is installed
with the feet in the tall position. Please contact service for one
to be shipped to you free of charge.
■ Align vent tab (B) with oven frame (A) as shown.
■ Using one #8-18 x 3/8" (9.5 mm) screw (C) on each side of
the vent tab (B), fasten the vent securely to the oven frame
(A).
A. Oven frame
B. Vent tab
C. #8-18 x 3/8" (9.5 mm)
screws
6. After the bottom vent shield is installed.
■ Align the Bottom vent tab (B) with the oven frame (A) as
shown.
■ Using one #8-18 x 3/8" (9.5 mm) screw (C) on each side of
the vent tab (B), align the top of the bottom vent tab (B) to
the Hinge receiver (D) as shown.
■ Fasten the bottom vent securely to the oven frame (A).
A. Oven frame
B. Vent tab
C. #8-18 x 3/8" (9.5 mm)
screw
D. Hinge receiver
7. Replace the oven racks.
8. Replace the oven door. See the “Replace Oven Door(s)”
section.
9. Check that the door is free to open and close. If it is not,
repeat the removal and installation procedures. See the
“Prepare Built-In Oven” section.
10. Repeat for lower oven door.
IMPORTANT: For proper oven operation, check that the gap
between bottom of the door and bottom vent is at least 1/4"
(6.4 mm)
11. Reconnect power.
12. The display panel will light and boot up.
13. If the display panel does not light, reference the Warranty.
C
B
A
A
C
B
D
B