Owner's Manual

9
Cabinet Dimensions - Double Ovens, Flush
Installations
NOTE: This is an alternate option to install your product in the
cabinet and obtain a flush look. For standard installation, refer
section "Cabinet Dimensions - Double Ovens, Standard
Installation".
A 25
3
/
8
" (64.4 cm) minimum cutout depth is required.
These dimensions will result in a 1/4" (6 mm) reveal on the top, a
1/4" (6 mm) reveal on the sides, and a 1/8" (3 mm) reveal on the
bottom of the wall oven.
The front face of the cleats and platform will be visible and should
be treated as a finished surface.
Double Ovens Installed in Cabinet
Front View
27" (76.2 cm) Models
A. 9/16" (1.4 cm) top cleat*
B. 27
1
/
4
" (69.2 cm) minimum
width of flush inset cutout
C. 25
7
/
8
" (65.7 cm) minimum
width of opening
D. 52
3
/
16
" (132.6 cm) minimum
height of flush inset cutout
E. 51
7
/
16
" (130.6 cm)
recommended cutout height
F. 11/16" (1.7 cm) side cleat*
G. 1/4" x 2" (0.64 cm x 5.1 cm)
spacer the entire depth of the
cutout*
H. Recommended junction box
location
I. 4
5
/
8
" - 14
3
/
4
" (11.7 - 37.5 cm)
bottom of cutout to floor
J. 25
3
/
8
" (64.4 cm) minimum
depth of cutout
Side View
30" (76.2 cm) Models
A. 9/16" (1.4 cm) top cleat*
B. 30
1
/
4
" (76.8 cm) minimum
width of flush inset cutout
C. 28
7
/
8
" (73.3 cm) minimum
width of opening
D. 52
3
/
16
" (132.6 cm) minimum
height of flush inset cutout
E. 51
7
/
16
" (130.6 cm)
recommended cutout height
F. 11/16" (1.7 cm) side cleat*
G. 1/4" x 2" (0.64 cm x 5.1 cm)
spacer the entire depth of the
cutout*
H. Recommended junction box
location
I. 4
5
/
8
" - 32" (11.7 - 81.3 cm)
bottom of cutout to floor
J. 25
3
/
8
" (64.4 cm) minimum
depth of cutout
* Cleats and spacers must be recessed 1
3
/
8
" (3.5 cm) from the
front of the cabinet.
NOTE: For this type of installation, contact Service and feet to
raise the unit will be provided
Top View
27" (68.6 cm) Models
A. 1/4" x 2" (0.64 cm x 5.1 cm)
spacer the entire depth of the
cutout*
B. 25
3
/
8
" (64.4 cm) depth of cutout
C. 1
3
/
8
" (3.5 cm) recess from front
of cabinet
D. 11/16" (1.7 cm) side cleat*
30" (76.2 cm) Models
A. 1/4" x 2" (0.64 cm x 5.1 cm)
spacer the entire depth of the
cutout*
B. 25
3
/
8
" (64.4 cm) depth of cutout
C. 1
3
/
8
" (3.5 cm) recess from front
of cabinet
D. 11/16" (1.7 cm) side cleat*
* Cleats and spacers must be recessed 1
3
/
8
" (3.5 cm) from the
front of the cabinet.
Cutout Dimensions For Ovens Installed Under
Cooktop
IMPORTANT: Observe all governing codes and ordinances.
Cooktop must be approved for use over an oven. See cooktop
Installation Instructions for cutout dimensions. Center the cooktop
cutout over oven cutout.
To avoid damage to your cabinets, check with your builder or
cabinet supplier to make sure that the materials used will not
discolor, delaminate or sustain other damage. This oven has been
designed in accordance with UL and CSA International and
complies with the maximum allowable wood cabinet temperatures
of 194°F (90°C).
Approved Built-In Oven and Electric Radiant/Coil Cooktop
Combinations
A. 24" (61 cm) cabinet depth
B. 25" (63.5 cm) countertop
depth
C. Recommended oven and
cooktop junction box
locations
D. Allow 5/8" (1.6 cm) for oven
trim to overlap on each side.
E. 27
3
/
4
" (70.5 cm) minimum
cutout height
F. 36" (91.4 cm) from cabinet
base to countertop
G. 4
5
/
8
" (11.7 cm) maximum from
cabinet base
H. See Cutout Dimensions chart.
I. 31
3
/
8
" (79.7 cm) from top of
countertop to bottom of cutout