Tech Sheet

9
FAILURE ERROR LIKELY FAILURE CONDITION
F1
Internal
E0 Oven user interface failure
SUGGESTED CORRECTIVE ACTION PROCEDURE
NOTE: Before starting any test, cycle power to the oven(power off, wait 10
seconds, and power on).
PROCEDURE: Before proceeding, verify the error codeby entering the
Diagnostics mode and selecting “Error Diagnostics.”
NOTE: If other error codes are stored, troubleshoot those other error codes
rst.
1. Unplug oven or disconnect power.
2. Conrm the control panel assembly is grounded to the oven chassis. If it
is, go to Step 6. If it is not, x the connection.
3. Reassemble all parts and panels before operating.
4. Plug in oven or reconnect power and cycle power.
5. If error persists unplug oven or disconnect power.
6. Replace HMI-Central/UI board.
7. Reassemble all parts and panels before operating.
8. Plug in oven or reconnect power and cycle power.
9. If error persists after HMI-Central/UI board is replaced, unplug oven or
disconnect power and replace Control Panel Assembly.
10. Reassemble all parts and panels before operating.
11. Plug in oven or reconnect power. Follow the on-screen prompts for model
selection.
12. Verify operation is normal. Enter Diagnostics mode, select “Error
Diagnostics,” and clear the history. If the Control Panel Assembly was
replaced, there is noneed to clear the error history.
FAILURE ERROR LIKELY FAILURE CONDITION
F1 E1 Internal oven ACU error
SUGGESTED CORRECTIVE ACTION PROCEDURE
NOTE: Before starting any test, cycle power to the oven(power off, wait 10
seconds, and power on).
PROCEDURE: Before proceeding, verify the error codeby entering the
Diagnostics mode and selecting “Error Diagnostics.”
NOTE: If other error codes are stored, troubleshoot those other error codes
rst.
1. Unplug oven or disconnect power.
2. Replace the Copernicus Appliance Manager.
3. Reassemble all parts and panels before operating.
4. Plug in oven or reconnect power.
5. If error persists after Copernicus Appliance Manager is replaced, unplug
oven or disconnect power, and then go to Step 6. If not, go to Step 9.
6. Replace Control Panel Assembly.
7. Reassemble parts and panels before operating.
8. Plug in oven or reconnect power.
9. Follow the on-screen prompts to select the modelnumber
10. Verify operation is normal. Enter Diagnostics mode, select “Error
Diagnostics,” and clear the history. If the Control Panel Assembly was
replaced, there is noneed to clear the error history.