Flush Kit Installation Instructions

6
Positioning Oven Feet
The oven feet need to be installed to allow a microwave/oven
combination to be installed in a recommended cutout height of
42
1
⁄
2
" (107.9 cm).
NOTE: Do not remove the spacers.
1. Using 2 or more people, place the oven on its back on a
covered surface.
2. Install a foot on the left rear spacer using a
#8-18 x 3/8" (9.5 mm) screw.
NOTE: Position the foot so the long side of the foot is facing
toward the top of the oven.
3. In the same manner, install a foot on the right rear of the
oven.
4. Install a front foot on the left front spacer using a
#8-18 x 3/8" (9.5 mm) screw.
NOTE: Position the foot so the long side of the foot is facing
toward the inside of the oven.
5. In the same manner, install a front foot on the right front of
the oven.
6. Using 2 or more people, place the oven in its upright
position.
7. Go to the “Make Electrical Connection” section in the
Installation Instructions provided with your built-in oven.
A. Spacers
A
A
B
C
A. Spacer
B. Foot
C. #8-18 x 3/8" (9.5 mm) screw
A. Front foot
B. #8-18 x 3/8" (9.5 mm) screw
C. Spacer
A
B
C
06-May-2019 13:38:42 EDT | RELEASED
In some European factories the letter "W" of the part code mentioned herein will be automatically
replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")