Installation guide

2
BUILT-IN MICROWAVE/OVEN COMBINATION SAFETY
INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools Needed
■ Phillips screwdriver
■ Measuring tape
■ Drill (for wall cabinet installations)
■ 1" drill bit (for wall cabinet installations)
■ Level
■ Flat-blade screwdriver
Parts Needed
■ UL listed or CSA approved conduit connector
■ UL listed wire connectors
■ Warming Drawer Deector Kit (for ovens installed
above a warming drawer)
White 27" (68.6 cm) kit
Black 27" (68.6 cm) kit
Stainless steel 27" (68.6 cm) kit
White 30" (76.2 cm) kit
Black 30" (76.2 cm) kit
Stainless steel 30" (76.2 cm) kit
Stainless steel/black 30" (76.2 cm) kit.
To order, see the “Assistance or Service” section
of the Use and Care Guide.
■ Flush Installation Kit (for Combo installed at ush installation)
Black 27" (68.6 cm) kit
Stainless steel 27" (68.6 cm) kit
Black 30" (76.2 cm) kit
Stainless steel 30" (76.2 cm) kit
Black 30" (76.2 cm) kit
Stainless steel 30" (76.2 cm) kit
To order, see the “Assistance or Service” section
of the Use and Care Guide.
Parts Supplied
■ #8-14 x 1" (2.54 cm) screws (4)
■ Bottom vent
■ #8-18 x 3/8" (9.5 mm) screws - bottom vent (2)
Check local codes. Check existing electrical supply. See
“Electrical Requirements.”
It is recommended that all electrical connections be made by a
licensed, qualied electrical installer.
Built-In Microwave/Oven
Combination Location
Requirements
IMPORTANT: Observe all governing codes and ordinances.
■ Cabinet opening dimensions that are shown must be used.
Given dimensions provide minimum clearance with oven.
■ Recessed installation area must provide complete enclosure
around the recessed portion of the oven.
■ Grounded electrical supply is required. See “Electrical
Requirements” section.
■ Electrical supply junction box should be located 3" (7.6cm)
maximum below the support surface when the oven is
installed in a wall cabinet. A 1" (2.5 cm) minimum diameter
hole should have been drilled in the left rear corner of the
support surface to pass the appliance cable through to the
junction box.