Refrigerator User Manual

Removing and Replacing the Automatic Ice Cube

Dispenser Bin

Lift the front of the Automatic Dispenser bin and pull it straight out. Wash the bin

occasionally in mild soap and lukewarm water. To replace the bin, push it at1the way

back until the bottom of the bin is behind the raised edge at the front of the shelf it rests

upon. Make sure the tabs, atthe back of the bin, that turn the spiral auger arepositioned

between the prongs from the auger motor.

I Operating Your Automatic Ice and Water Dispenser {

Water/Ice Control

For dispensing ice cubes, the slide control must be

moved to the "Cube" position (center). For dispensing _._,,,..,_

crushed ice, move the controlto the "Crushed" position _/-

(left). c.................

For dispensing chilled water, the slide control must be : ( _ ii

moved completely to the "Water" position (right). I

WaterfromthaO,sponser,soh,,ed,ce,dorwatar llil li

simp,addiceOefo adispensingthewa,ar.,so.the liL: l]first glass of water dispensed each time may be warmer

than consecutive glasses. It will be cooler if a full glass

of water is dispensed rather than a partial glass. Fill a

container with ice before adding liquidto prevent splash-

ing.

Dispensing

To fill a glass, position the glass against the top portion

ofthe actuator pad andpress. Hold the glass high inthe

dispenser opening to reduce the ice falling outside _,

the glass.

Some crushed ice may be dispensed even though you

selected CUBE. This happens occasionally whena few

cubes accidentally get channeled in the crusher,

When changingfromcrushediceto cubes somecrushed

ice may bedispensed. This ma

sized cubes or ice chips are in the storage bin.

There may be adelay when you switch fromcubes to crushed ice. Ittakes afew sect

for the cubes to be channeled in the crusher. Crushed ice pieces will vary in size

shape.