Refrigerator User Manual

ILocation ]
If you are installing your new refdgerator yourself, please follow these helpful su§
tions.
Jii LJlJ J!: I
1. Remove base skids. , [I J
2. Remove all exterior and interior tape carefully and ._lli
retain old tape. Make a small pad of this tape to pick
offany remainingtaperesidues. Thiswilleliminatethe '&_
need to use dangerous solvents of any kind.
3. Removeand discardthe cantilever shelf packingclips
located just above each shelf where they hook onto
the frame. To remove the red plastic clip, wiggle it
sideways and pull straight out.
4. Select a location for your new refrigerator away from any heat sources. Allow ;
flow of air through the front base grille.
5. Your model should not be installed where the room temperature will go bel
55° F. because it will not run frequently enough to maintain proper temperat_
the freezer.
[Leveling Is Important I
To enhance its appearance, maintain efficient performance and for proper func
the ice maker, your refrigerator should be level. Using a carpenter's level, ohec:
refrigeratorto make sure it is level frontto back and side toside. The front wheel.'
adjusted at the factory so the cabinet would be level. However, jarring in trar
standing the refrigerator onan uneven floormaycause the doors to shiftout of aligr
ff leveling is necessary, remove the base grille and adjust the wheel with a scre_
as shown.
To lock the cabinet in place, turn down one or both .o,_.c.,a_-r
locking feet, located near the front wheels. Rear
leveler feet are not required.
TURNCOUNTER_t.OCk'_VI_E
! _L-_ ! TOCORRE_TTH,SCONDI* []
TION, RAISE RIGHT COR- TO CORRECT THIS CONOW[DN.
NER AND/OR LOWER LBFT LEFT CORNER AND/OR LOWER
CORNER UNTIL DOORS CORNERUNTILOOORSAUGN
ALIGN ACROSS TOP OF TO_ OF CABINET.
CABINET.
4