Installation Instructions

12
HOOD USE
The hood is designed to remove smoke, cooking vapors and
odors from the cooktop area. For best results, start the hood
before cooking and allow it to operate several minutes after
the cooking is complete to clear all smoke and odors from the
kitchen.
The hood controls are located on the front side of the canopy.
A. Louver holes (non-vented
[recirculating] installations only)
B. Upper duct covers
C. Lower duct covers
D. LED lights (1)
E. Metal grease lters (located
behind the perimetic cover)
F. Perimetic cover
G. Canopy
H. Control panel
Controls and Features
The hood is tted with a control panel with aspiration speed
selection control and a light switch to control cooking area lights.
T1 = Motor ON/OFF button - 1st speed.
T2 = 2nd speed.
T3 = 3rd speed.
T4 = 4th Speed.
Timed On/Off Boost, after 5 minutes the hood returns to the
previously set speed.
T5 = Light ON/OFF button.
T6 = Reset Button for lters:
The lters must always be reset with the motor running.
The hood will warn the user that it is time to do maintenance work
on the lters, by giving out a light-signal.
Flashing Button: carry out the maintenance of the greasy lters,
following this press the button for over 3 seconds and the button
will turn off.
Lit Button: carry out maintenance on carbon-lters, following this
press the button for more than 3 seconds, the button will switch
off.
Attention: the hood is provided only with a warning signal for
greasy lters.
To put into function the greasy-lter signal:
Set the hood off, press switch button number 6 for more than 3
seconds, the switch will turn on signalling that the function has
been set.
To deactivate the carbon lter signal, repeat the entire procedure
again.
Functions
Fan Speeds
Min Press MIN FAN to turn the fan on at Minimum
speed.
Med Press MED FAN to turn the fan on at Medium
speed.
Max Press MAX FAN to turn the fan on at Maximum
speed.
Boost Press BOOST to turn the fan on at the highest
speed. Boost will automatically turn Off after
5 minutes and the fan will switch to High speed.
Control Panel