installation instructions

20
To Convert IR Grill Burner for Propane
1. Unplug range or disconnect power.
2. Remove grill knob and bezel. The other surface knobs and
bezels should still be off the range.
3. Open the oven door and remove the two screws on each
side of the range that hold the control console in place.
NOTE: Make sure to leave oven door open or the control
console will not rest in the side brackets properly once it is
detached.
4. Pull up on the control console and let it drop forward into the
notched console brackets on each side.
5. Remove the two screws holding the grill orice holder
bracket.
6. Pull the grill orice holder out of the burner box far enough
away to allow access to the orice with a wrench, using
caution not to kink the attached tubing.
7. Using an adjustable wrench and a 1/2" (1.3 cm) open end
wrench remove the Natural (NG) gas orice spud and replace
with the correct Propane (L) orice spud.
8. Reposition the grill orice holder assembly back into the
burner box, and replace the grill orice holder bracket and
two holder screws.
9. Lift up on the control console and set it back into place. For
a proper t, the ange of the control console must hook over
the lip on the front of the range cooktop.
NOTE: It may be necessary to lift valve stems to align with
console holes.
A
A. Control console bracket
A
B
A. Screws
B. Grill orice holder bracket
A
B
A. Grill orice
B. Grill orice holder
Use 1/2" (1.3 cm)
open end wrench
to remove/replace
orifice
Hold with adjustable
wrench here
A
B
A. Control console ange
B. Front lip of range cooktop