installation instructions

30
6. Pull the grill orice holder out of the burner box far enough
away to allow access to the orice with a wrench, using
caution not to kink the attached tubing.
7. Using an adjustable wrench and a 1/2" (1.3 cm) open end
wrench remove the Propane (L) orice spud and replace with
the correct Natural Gas (NG) orice spud. See Natural Gas
Orice Spud Chart.
8. Reposition the grill orice holder assembly back into the
burner box, and replace the grill orice holder bracket and
two holder screws.
9. Lift up on the control console and set it back into place. For
a proper t, the ange of the control console must hook over
the lip on the front of the range cooktop.
NOTE: It may be necessary to lift valve stems to align with
console holes.
10. Check that the control console is ush with the top edge of
the range.
11. Replace the screws on each side of the control console.
12. Replace the control knobs and bezels.
13. Replace burner grates.
Convert Oven Bake Burner (30" [76.2 cm] and 36"
[91.4 cm] models and the right oven cavity on 48"
[121.9 cm] models)
1. Slide the bake burner cover to the right or left.
2. Lift up and remove oven bake burner cover, and set aside.
3. Using a 1/4" (6.4 mm) nut driver, unscrew oven bafe nuts
and remove oven bafe. Set aside.
A
B
A. Grill orice
B. Grill orice holder
Use 1/2" (1.3 cm)
open end wrench
to remove/replace
orifice
Hold with adjustable
wrench here
A
B
A. Control console ange
B. Front lip of range cooktop
A
A. Flush with range top
A
A. Bake burner cover
B
A
A. Oven bafe
B. Oven bafe nuts