installation instructions

23
Replace Oven Bake Burner Cover
1. Align notches on the oven bake burner cover with shoulder
screws in the bottom of the oven.
2. Lower cover, and slide to left or right to slide shoulder
screws into the narrow ends of the notches, then lock
intoplace.
Convert Oven Broil Burner (30" [76.2 cm] and 36"
[91.4 cm] models and the right oven cavity on 48"
[121.9 cm] models)
1. Using a 1/4" (6.4 mm) nut driver, remove broil burner screw.
Set aside with side igniter positioned on the right.
2. Pull the broil burner toward you until it slides out of the hole
in the oven back, and pull the electrode out of the bracket.
The broil burner will hang down in the back of the oven while
you change the orice.
3. Apply masking tape to the end of a 1/4" (6.4 mm) nut driver
to help hold the gas orice spud in the nut driver while
changing it. Insert nut driver into the gas opening, and press
down onto the gas orice spud, then remove by turning the
gas orice spud counterclockwise and lifting out. Set gas
orice spud aside.
4. Gas orice studs are stamped with a letter and a number.
Install the Number 90 oven broil burner orice spud.
5. Place Natural gas orice in plastic parts bag for future use,
and keep with package containing literature.
6. Replace the broil burner in the hole in the oven back with the
broil burner assembly inside the broil burner electrode hole
as illustrated.
7. Reinstall the oven broil burner screw. See Step 1 for
illustration. The screw is aligned with the hole when
aclicksounds.
B
A
B
A
A. Cover notches (4)
B. Shoulder screws (4)
A
A. Bake burner cover
B
A
C
A. Broil burner screw
B. Broil burner
C. Broil burner orice hole
A
B
A. Grasp electrode here.
B. Bracket
Broil burner hanging
in back of oven
A
B
C
A. Oven back
B. Broil burner orice
C. Broil burner orice hole
A
B C
A. Broil burner orice hole
B. Broil burner electrode
C. Broil burner electrode hole