Instruction Sheet

ManualsBrandsJennAir ManualsRefrigerator AccessoriesJennAir Stainless Steel Handle To Handle Join Kit

SITE PREP

MULTIPLE COLUMN REFRIGERATION

1. CHECK THE FURNITURE



Measure to make sure all opening dimensions are correct.



Side panel construction: 3/4" (1.9 cm) thick plywood.

IMPORTANT: Cannot be constructed of pressed ﬁber material such

as MDF.



Sofﬁt height: 84" (213.4 cm).



The bottom panel must consist of 3⁄4" plywood.



The offset between the bottom edge of the sofﬁt cabinet’s bottom

rail and the 3⁄4" bottom plywood must not exceed 1⁄8".



The 3⁄4" plywood bottom panel must extend laterally to directly

contact the left and right side panels and be securely fastened along

its depth.



A single water supply line may be split 2 or 3 ways to service all

columns.

2. CHECK THE INSTALLATION SITE



Away from ovens, radiators or other heat sources.



Temperature will not fall below 55° F (13° C).



Floor supports more than 600 lbs. (272 kg)

plus door panel and contents weight.



Floor level with the room.



Furniture face plumb.

WARNING

Explosion Hazard

Keep flammable materials and vapors, such

as gasoline, away from refrigerator.

Failure to do so can result in death,

explosion, or fire.

WARNING

Tip Over Hazard

Refrigerator is top heavy and tips easily when

not completely installed.

Keep doors taped closed until refrigerator is

completely installed.

Use two or more people to move and install

refrigerator.

Follow installation instructions.

Failure to do so can result in death or serious

injury.

Sofﬁt cabinet

bottom rail

Sofﬁt cabinet base panel extends

to side panels (both sides)

Max. offset 1/8"

3/4"

84"

W10919013A 07/18

Summary of content (2 pages)

PAGE 1
SITE PREP MULTIPLE COLUMN REFRIGERATION 1. CHECK THE FURNITURE   Measure to make sure all opening dimensions are correct.  Away from ovens, radiators or other heat sources.  Temperature will not fall below 55° F (13° C).  Floor supports more than 600 lbs. (272 kg) Side panel construction: 3/4" (1.9 cm) thick plywood. IMPORTANT: Cannot be constructed of pressed fiber material such  Soffit height: 84" (213.4 cm). Tip Over Hazard plus door panel and contents weight. as MDF.  WARNING 2 .
PAGE 2
PRÉPARATION DU SITE MULTIPLES RÉFRIGÉRATEURS ENCASTRÉS 1 . VÉ R I F I CAT I O N D U M E U B L E  Mesurer pour s’assurer que toutes les dimensions de l’ouverture sont 2 . VÉ R I F I CAT I O N D U S I T E D’ I N STA L L AT I O N  Loin des fours, radiateurs et autres sources de chaleur.  La température ne descend pas sous 55 °F (13 °C).  Le plancher doit pouvoir supporter plus de 600 lb. (272 kg) en plus bonnes.  Fabrication du panneau latéral : Contreplaqué de 3/4 po (1,9 cm) d’épaisseur.