Instruction Sheet

INTRODUCTION 21
SITE PREP
3. CHECK THE WATER SUPPLY

Water supply meets local plumbing codes.

Water shutoff in base cabinet, as shown,
or accessible area.

Access hole through the cabinet is within 1/2"
(1.3 cm) of the rear wall.

Install any additional tubing only where
temperatures remain above freezing.
Check for leaks.

Not using a piercing-type or 3/16" (4.8 mm)
saddle valve. See refrigerator dealer for
saddle-type valve kit that complies with
local plumbing codes.

If water pressure to reverse osmosis system
is less than 40 to 60 psi (276 to 414 kPa):
• Check sediment filter to see if it is blocked.
Replace filter if necessary.
• Allow the storage tank to refill after
heavy usage.
• Remove the water filter cartridge.
No filter bypass is necessary.
WATER SUPPLY REQUIREMENTS
Water Pressure 30 – 120 psi (207 – 827 kPa)
Water Pressure to
Reverse Osmosis
System
Minimum 40 – 60 psi
(276 – 414 kPa)
Excess Water Line
for Connection
30" (76.2 cm)
Supply 1/4" OD copper, braided
stainless steel or PEX tubing
IF YOU HAVE QUESTIONS ABOUT YOUR WATER SUPPLY,
CALL A LICENSED, QUALIFIED PLUMBER.
Water shutoff
Access hole
(within 1/2" of rear wall)
?