Instruction Sheet
Table Of Contents
- Range Safety
- Installation Requirements
- Installation Instructions
- Gas Conversions
- Sécurité de la cuisinière
- Exigences d’installation
- Instructions d’installation
- Déballage de la cuisinière
- Retirer la porte
- Installation de la bride antibasculement
- Raccordement au gaz
- Vérification de l’emplacement de la bride antibasculement
- Installer le plateau d’égouttement
- Système d’allumage électronique
- Ajustement de l’aplomb de la cuisinière
- Installer la plinthe
- Terminer l’installation
- Conversions pour changement de gaz
10
INSTALLATION INSTRUCTIONS
Unpack the Range
Remove shipping materials, tape, and lm from range.
Keepshipping pallet under range. Remove oven racks, and parts
package from inside oven. Remove grates from top of oven.
Remove Kick Plate
1. Your range will have the kick plate packaged on top of the
unit.
a. Remove kick plate from top of range and grate pack.
b. Lay kick plate to the side to avoid scratching.
2. For 48" (121.9 cm) models only, rotate center support
counterclockwise off the pallet until it stops.
NOTE: This support is used only for shipping and is not
needed for installation.
3. Lay a piece of cardboard from packaging on the oor behind
range. Using two or more people, rmly grasp each side of
range. Lift range up about 3" (8.0 cm) and move it back until
range is off shipping pallet. Set range oncardboard to avoid
damaging oor.
WARNING
Excessive Weight Hazard
Use two or more people to move and install range.
Failure to do so can result in back or other injury.
In packaging
A. Kick plate
A
Packaging removed
A. Kick plate
A
16-Jan-2019 04:15:34 EST | RELEASED
In some European factories the letter "W" of the part code mentioned herein will be automatically
replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")